Results 91 to 100 of about 822,229 (216)
Materials and Corrosion, Volume 77, Issue 9, Page 1579-1594, September 2026.Schematic depicting corrosion layer formation and changes in stainless steel exposed to Solar Salt at 600°C for 1000 h under different atmospheres: (a) N2 accelerates salt decomposition, producing nitrite and oxide ions, causing severe corrosion. (b) Adding O2 reduces nitrite ions formation, resulting in less corrosion than N2 alone.
Sumit Kumar +4 more
wiley +1 more source
工程科学与技术, 2023 To explore both static and seismic performances of stainless steel beam-to-column minor-axis joints, a total of four minor-axis joints with end-plate connections were designed and fabricated, involving two austenitic stainless steel joint specimens and ...
Jundong GAO +5 more
doaj
Materials and Corrosion, Volume 77, Issue 9, Page 1399-1423, September 2026.The localized corrosion behavior of lean duplex stainless steel EN 1.4062 is systematically compared with austenitic and higher‐alloyed duplex grades in natural seawater. A clear resistance ranking is established, highlighting EN 1.4062 as a cost‐effective alternative for limited marine exposure.
Mohammad Hassanzadeh +4 more
wiley +1 more source
MATEC Web of Conferences, 2018 Nowadays engine capacities of vehicles spread in a wide range due to different vehicle power demands. Power density of engines affects exhaust gas and therefore exhaust gas temperature varies from 650 °C to 1000 °C in exhaust manifolds.
Çelik G. Aktaş +3 more
doaj +1 more source
Acta Metallurgica Slovaca, 2017 This paper investigates the changed in the microstructure in HAZ of the dissimilar weld between carbon steel and 304 austenitic stainless steel. Continuous cooling transformation diagrams (CCT), peak temperature profiles and cooling rates can be used to ...
Le Thi Nhung +3 more
doaj +1 more source
Materials and Corrosion, Volume 77, Issue 9, Page 1424-1437, September 2026.This article examines the impact of externally introduced chromium compounds on the localized corrosion of 316 L stainless steel in acidic chloride environments such as hydrochloric acid. While the corrosion resistance of 316 L relies on the formation of a chromium‐rich passive oxide layer, industrial conditions may expose the steel to various chromium
Florence Lequien
wiley +1 more source
Influence of Strain Rate on the Strain Hardening Behavior of a Lean Duplex Stainless Steel
MetalMat, Volume 3, Issue 3, September 2026.The aim of this study was to examine how strain rate influences the compressive strain‐hardening behavior of a lean duplex stainless steel LDX 2101. Microstructural analysis using electron backscatter diffraction (EBSD) revealed a strain‐induced austenite‐to‐martensite transformation.
Akilakpa Sawyerr +4 more
wiley +1 more source
Actuation Strategies for Underwater Jet‐Propelled Soft Robots
Journal of Field Robotics, Volume 43, Issue 6, Page 3868-3892, September 2026.ABSTRACT This review article examines jet‐propulsion mechanisms in underwater soft robotic systems, focusing exclusively on physically fabricated and experimentally validated robots. Covering research published from 2013 to 2025, this study classifies and evaluates jet‐propulsion robots based on their actuation mechanisms.
Angel Kitone +3 more
wiley +1 more source
Effects of Cr2N Precipitation on the Antibacterial Properties of AISI 430 Stainless Steel
Metals, 2016 Based on their mechanical properties and good corrosion resistance, some commercial Ni-Cr stainless steels have been widely applied as biomaterials, including the austenitic 304 stainless steel, the austenitic 316 stainless steel, the duplex 2205 ...
Je-Kang Du +4 more
doaj +1 more source
steel research international, Volume 97, Issue 9, Page 4889-4904, September 2026.Creep behavior of SS 316 brackets is examined through experiments, conventional creep laws, and advanced constitutive modeling. Long‐term deformation, stress redistribution, and life prediction are compared under service‐relevant loads. The study highlights the limits of classical models and demonstrates improved accuracy using advanced approaches for ...
Mohsin Sattar +7 more
wiley +1 more source