Results 131 to 140 of about 2,322 (176)
Hydrogen-Dislocation Interactions at Cryogenic Temperatures: Serrated Yielding and Embrittlement Resistance in High-Strength Austenitic Alloys. [PDF]
Materials (Basel)Damm N +10 more
europepmc +1 more source
A review of the corrosion and wear resistance mechanisms of gas nitriding on steel. [PDF]
iScienceLi J, Shao H, Lu K.
europepmc +1 more source
Improved radiation resistance in metals via adaptive martensitic transformation. [PDF]
Nat CommunZhang S +7 more
europepmc +1 more source
Nanostructure and Corrosion Resistance of Plasma-Based Low-Energy Nitrogen Ion Implanted 17-4PH Martensitic Stainless Steel. [PDF]
Nanomaterials (Basel)Yang X, Che H, Li S, Lei M.
europepmc +1 more source
Effect of Solution Process on Microstructure and Properties of Cr-Mn-N Austenitic Stainless Steel. [PDF]
Materials (Basel)Dong X +6 more
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Surface and Coatings Technology, 1996
Abstract It has been shown previously in the literature that plasma immersion ion implantation (PHI) can increase the wear resistance of austenitic stainless steel without losing its corrosion resistance. In this work, the effect of PHI treatment on the microstructure and the properties of an austenitic (X6CrNiTi1810, AISI 321) and a duplex ...
C. Blawert +3 more
openaire +1 more source
Abstract It has been shown previously in the literature that plasma immersion ion implantation (PHI) can increase the wear resistance of austenitic stainless steel without losing its corrosion resistance. In this work, the effect of PHI treatment on the microstructure and the properties of an austenitic (X6CrNiTi1810, AISI 321) and a duplex ...
C. Blawert +3 more
openaire +1 more source
Sliding wear of austenitic and austenitic-ferritic stainless steels
Metallurgical and Materials Transactions A, 2002The dry sliding behavior of a 304L austenitic stainless steel and a duplex 2205 austenitic-ferritic stainless was investigated. The evolution of wear was characterized by the existence of a sliding-distance transition. In particular, wear passed from delamination to tribo-oxidation, with a reduction in wear rate. The occurrence of such a transition was
Straffelini, Giovanni +2 more
openaire +2 more sources
Anelasticity in austenitic stainless steel
Acta Materialia, 2012Time-dependent anelastic deformation mechanisms arise in austenitic stainless steel when load is removed during a high-temperature creep test. This phenomenon is investigated by conducting creep tests, with intermittent load removal, on AISI Type 316H austenitic stainless steel at 550 and 650 °C, supported by in situ measurement of creep-induced ...
Ashwin Rao +3 more
openaire +1 more source
Magnetism in Austenitic Stainless Steels
Journal of Applied Physics, 1970Mössbauer-effect measurements of the temperature dependence of the hyperfine field for several austentic stainless steels are reported. Antiferromagnetic transitions were observed for all specimens in the temperature range below 56°K. In addition, a broadening of the single linewidth occurred for each specimen at a temperature near its transition ...
L. D. Flansburg, N. Hershkowitz
openaire +1 more source