Results 131 to 140 of about 194,426 (295)

Integrating Patient‐Reported Quality Measures in Systemic Lupus Erythematosus: Development of the American College of Rheumatology Implementation Guide

Arthritis Care &Research, EarlyView.
Objective To support high‐quality, patient‐centered care for systemic lupus erythematosus (SLE), the American College of Rheumatology (ACR) developed evidence‐based measures incorporating clinical and patient‐reported outcome measures (PROMs). Using the Consolidated Framework for Implementation Research (CFIR), we conducted semistructured interviews ...
Catherine Nasrallah, Cherish Wilson, Christine Hariz, Christie M. Bartels, Shanthini Kasturi, Wambui Machua, Amy Bennett, Kate Chiseri, Allison Plitman, Starla Hairston Blanks, April Jorge, Patti Katz, Jinoos Yazdany, Shivani Garg   +13 more
wiley   +1 more source

Triangular Index Ratio as An Alternative Method to the Alpha Angle for Defining the Presence of Cam Morphology: A Prospective Cohort Study

Arthritis Care &Research, Accepted Article.
Objective Cam morphology, a significant risk factor for hip osteoarthritis, is commonly quantified by the alpha angle (AA). This study aims to explore the potential of the triangular index ratio (TIR) to quantify cam morphology on anteroposterior radiographs by assessing the association between TIR‐defined cam morphology and the development of ...
Jinchi Tang, Fleur Boel, Michiel M. A. van Buuren, Noortje S. Riedstra, Myrthe A. van den Berg, Jos Runhaar, Sita Bierma‐Zeinstra, Rintje Agricola   +7 more
wiley   +1 more source

Effects of Causal Beliefs About Gout on Public Views About Gout Management: A Randomized Experimental Study

Arthritis Care &Research, EarlyView.
Objective Despite well‐described biologic causes, the public views unhealthy lifestyle choices as the primary cause of gout. This study investigated how causal beliefs about gout influence the public's views about its management. Methods In a randomized study, 201 members of the public viewed one of two 2‐minute videos about gout.
Rachel Murdoch, Borislav Mihov, Anne Horne, Keith J. Petrie, Gregory D. Gamble, Lachlan Fleck, Nicola Dalbeth   +6 more
wiley   +1 more source

A Robust Adaptive One‐Sample‐Ahead Preview Super‐Twisting Sliding Mode Controller

International Journal of Adaptive Control and Signal Processing, EarlyView.
Block Diagram of the Robust Adaptive One‐Sample‐Ahead Preview Super‐Twisting Sliding Mode Controller. ABSTRACT This article introduces a discrete‐time robust adaptive one‐sample‐ahead preview super‐twisting sliding mode controller. A stability analysis of the controller by Lyapunov criteria is developed to demonstrate its robustness in handling both ...
Guilherme Vieira Hollweg, Paulo Jefferson Dias de Oliveira Evald, Shivam Chaturvedi, Hilton Abilio Gründling, Rodrigo Varella Tambara, Wencong Su   +5 more
wiley   +1 more source

Enumeration of r-smooth words over a finite alphabet [PDF]

Discrete Mathematics Letters, 2023
Toufik Mansour, José L. Ramírez, Diego Villamizar   +2 more
doaj   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

NFDI MatWerk Ontology (MWO): A BFO‐Compliant Ontology for Research Data Management in Materials Science and Engineering

Advanced Engineering Materials, EarlyView.
This article presents the NFDI‐MatWerk Ontology (MWO), a Basic Formal Ontology‐based framework for interoperable research data management in materials science and engineering (MSE). Covering consortium structures, research data management resources, services, and instruments, MWO enables semantic integration, Findable, Accessible, Interoperable, and ...
Hossein Beygi Nasrabadi, Ebrahim Norouzi, Kostiantyn Hubaiev, Jörg Waitelonis, Harald Sack   +4 more
wiley   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

A Thermodynamic 3D Model for the Simulation of Diffusion‐Controlled Alloying Processes in Heterogeneous Material Structures

Advanced Engineering Materials, EarlyView.
A numerical model resulting from irreversible thermodynamics for describing transport processes is introduced, focusing on thermodynamic activity gradients as the actual driving force for diffusion. Implemented in CUDA C++ and using CalPhaD methods for determining the necessary activity data, the model accurately simulates interdiffusion in aluminum ...
Ulrich Holländer, Leonhard Holländer, André Langohr, Hans Jürgen Maier   +3 more
wiley   +1 more source