Results 1 to 10 of about 43,527 (252)

Auxiliary Propulsion Based on Wave Energy Converters

open access: green, 2021
This study presents a proof of concept for new auxiliary propulsion. The proposed design includes open to the sea ship compartments. Seawater oscillates inside the specially shaped compartments due to the relative ship motions in waves. The curved profile of these compartments deflects the water backwards from its natural vertical flow, and the water ...
Nick Markov   +3 more
  +4 more sources

A Novel Enhanced Connection of AC/AC Powertrain for HEV - Modelling and Simulation Results [PDF]

open access: yesAdvances in Electrical and Electronic Engineering, 2018
The paper deals with a novel enhanced connection of AC/AC powertrain for Hybrid Electric Vehicles (HEV). The substantial contribution of such a connection is the absence of 4QC auxiliary converter needed for autonomous and hybrid operational modes and ...
Branislav Dobrucky   +2 more
doaj   +4 more sources

Loss Model and Efficiency Analysis of Tram Auxiliary Converter Based on a SiC Device [PDF]

open access: goldEnergies, 2017
Currently, the auxiliary converter in the auxiliary power supply system of a modern tram adopts Si IGBT as its switching device and with the 1700 V/225 A SiC MOSFET module commercially available from Cree, an auxiliary converter using all SiC devices is ...
Hao Liu   +3 more
doaj   +2 more sources

A ZVT Auxiliary Circuit for High Step-Up Multi-Input Converters with Diode-Capacitor Multiplier

open access: diamondMajlesi Journal of Electrical Engineering, 2021
In this paper, a Zero-Voltage Transition (ZVT) non-isolated high step-up multi-input DC-DC converters is proposed which employs an auxiliary cell and diode-capacitor multiplier.
Sayed Hossein Mirlohi   +2 more
doaj   +2 more sources

Soft switching DC/DC converter using auxiliary circuits

open access: greenJournal of Electrical and Electronics Engineering, 2008
A novel auxiliary circuit for full-bridge PWMDC/DC converter with controlled secondary side rectifieris presented in this paper. Zero-current turn-on for allpower switches of the inverter is achieved for full loadrange from no-load to short circuit by using controlledrectifier and auxiliary circuit on the secondary side.Modified phase shift PWM control
Jaroslav Dudrik, Vladimír Ruščin
openalex   +2 more sources

An AC-DC Interleaved ZCS-PWM Boost Converter With Reduced Auxiliary Switch RMS Current Stress

open access: yesIEEE Access, 2021
The paper proposes a novel interleaved AC-DC ZCS-PWM boost converter that requires the use of just a single active auxiliary switch to assist in the turning off the main power circuit switches with ZCS.
Ramtin Rasoulinezhad   +3 more
doaj   +1 more source

A new high step-up active clamp DC-DC converter with high efficiency [PDF]

open access: yesSerbian Journal of Electrical Engineering, 2023
In this paper, a new high step-up converter with a simple structure is presented. The auxiliary circuit of the proposed converter is in the form of active clamp, which provides soft switching condition under zero voltage for the main and ...
Vesali Mahmood
doaj   +1 more source

Implementation of Soft-Switching Auxiliary Current Control for Faster Load Transient Response

open access: yesIEEE Access, 2021
A control circuit for the auxiliary buck/boost converter was designed and implemented to improve the load transient response of the buck converter. The circuit shapes the auxiliary inductor current in the critical conduction mode through peak current ...
Dongwook Kim   +4 more
doaj   +1 more source

Insights on DAB Converter with Auxiliary Inductors

open access: yes2023 International Conference on Clean Electrical Power (ICCEP), 2023
Dual-active-bridge (DAB) converters have gained popularity primarily owing to their appealing features for electric vehicle (EV) charging and smart-grid applications. One among them is soft-switching commutation that comes inherently with the device control techniques.
Pittala L. K.   +5 more
openaire   +2 more sources

Beijing converters: bridge converters with a capacitor added to reduce leakage currents, DC-bus voltage ripples, and total capacitance required [PDF]

open access: yes, 2017
: Isolation transformers and bulky electrolytic capacitors are often used in power electronic converters to reduce leakage currents and voltage ripples but this leads to low power density and reduced reliability.
Ming, Wen-Long   +3 more
core   +2 more sources

Home - About - Disclaimer - Privacy