Results 201 to 210 of about 2,196,882 (335)

Effect of reconstruction settings on radiomics feature robustness in positron emission tomography images: a clinical study. [PDF]

Quant Imaging Med Surg
Liu Y, Wang G, Yan X, Wang H, Li T, Yang S, Liu Z, Zhang S, Su X.   +8 more
europepmc   +1 more source

Improved Bounds for the Average Run Length of Control Charts Based on Finite Weighted Sums [PDF]

, 1990
Walter Böhm, Peter Hackl
openalex   +1 more source

Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6

Advanced Engineering Materials, EarlyView.
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter, Thomas Wegener, Andreas Schilling, Martin Fehlbier, Thomas Niendorf   +4 more
wiley   +1 more source

In silico analysis of sodium ion permeation mechanisms in transient receptor potential vanilloid 1. [PDF]

Sci Rep
Nagasato Y, Sanematsu K, Kawabata Y, Takai S, Nakamura S, Matsui T, Shigemura N.   +6 more
europepmc   +1 more source

Average Run-length under different load forces on a cargo with ensembles of two motors, wild type and mutant (WW, WM and MM).

, 2016
Shreyas Bhaban, Materassi Donatello, Li Mingang, Hays Thomas, Salapaka Murti   +4 more
openalex   +2 more sources

Percentiles of the run-length distribution of the Exponentially Weighted Moving Average (EWMA) median chart [PDF]

, 2017
KhimLeng Tan, Zhi Lin Chong, Michael B. C. Khoo, Wei Lin Teoh, Sin Yin Teh   +4 more
openalex   +1 more source

Mechanically Deposited Wear‐Resistant Amorphous Zr55Cu30Al10Ni5 Coatings

Advanced Engineering Materials, EarlyView.
Mechanically deposited from glassy ribbons, the Zr55Cu30Al10Ni5 amorphous coating formed a hard, continuous layer on AISI 1010 steel, tripling substrate hardness, lowering friction, and reducing wear. Despite its rough surface, it showed friction and wear behavior comparable to the crystalline alloy, highlighting its strong potential as a durable ...
Tales Ferreira, Pietro Cazelatto Bortolini, André Luiz Vidilli, Paulo Wilmar Barbosa Marques, Jéferson Aparecido Moreto, Claudio Shyinti Kiminami, Walter José Botta, Claudemiro Bolfarini, Guilherme Yuuki Koga   +8 more
wiley   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

Developmentally dynamic chromatin state at loci regulating organ crosstalk by remote sensing and signaling. [PDF]

Epigenetics Chromatin
Parmar A, Nigam SK, Cai K, Falah K, Ermakov VS, Wang K, Ferguson CJ.   +6 more
europepmc   +1 more source

Analytical Explicit Formulas of Average Run Length of DEWMA Control Chart based on Seasonal Moving Average Process

Rapin Sunthornwat, Yupaporn Areepong, Saowanit Sukparungsee   +2 more
openalex   +1 more source