Results 241 to 250 of about 3,329,474 (283)

Magnetic Field and Specific Axial Load Capacity of Hybrid Magnetic Bearing

IEEE Transactions on Magnetics, 2013
Permanent magnet bias hybrid magnetic bearing (HMB) which combines active and passive actuators in one unit is very suitable for rotational applications in spacecraft. In the past, numerous studies focusing on the active actuator have been widely reported. However, few have addressed on the passive unit which is essential to the suspension system.
Haoze Wang
exaly   +2 more sources

Analysis of Axial Bearing Capacity

2020
In the reinforced CFST, there are more than one steel tube to confine the concrete, so its compressive behavior is different from the ordinary CFST. Compressive strength is an important parameter for structural members, and most of the researches were concentrated on the superposition method to calculate the ultimate compressive strength (Zhang et al ...
Yufen Zhang, Degang Guo
openaire   +1 more source

Calculation of the axial bearing capacity of tapered bored piles

Proceedings of the Institution of Civil Engineers - Geotechnical Engineering, 2013
Fourteen calibration chamber tests were performed on one cylindrical pile and two tapered piles with different taper angles to investigate how the bearing capacity of tapered piles varies in relation to the soil state and the taper angle of the piles. The results show that the ultimate unit base resistance of a tapered pile increases when there is an ...
Kyuho Paik, Junhwan Lee, Daehong Kim
openaire   +1 more source

The axial load-carrying capacity of radial cylindrical roller bearings

Tribology, 1970
Thrust load transmission at the contact areas of roller ends and flanges occurs under conditions of pure sliding. Recent theoretical and experimental investigations showed that with adequately designed roller ends and flanges and with a satisfactory lubricant high thrust loads can be accommodated over a wide speed range with fully hydrodynamic ...
  +4 more sources

Bearing Capacity of the Corrosion Reinforced Concrete Axial Compression Members

Advanced Materials Research, 2012
based on the relationship between steel rust expansion force and the amount of corrosion, regarding reinforced concrete as a general continuum with the use of integral model, the finite element analysis models of axial compressive members were set up.
Guo Ye Wang, Zhi Pan Wang, Yu Yin, Feng Chi Wang   +3 more
openaire   +1 more source

Axial Response and Bearing Capacity of Tapered Piles in Sandy Soil

Geotechnical Testing Journal, 2011
Abstract 14 calibration chamber tests were performed to investigate the axial responses of tapered piles in sandy soil. Three instrumented model piles with different taper angles, designed to have the same volume, were used in the tests.
Kyuho Paik, Junhwan Lee, Daehong Kim
openaire   +1 more source

Investigation of Axial Carrying Capacity of Radial Hybrid Magnetic Bearing

IEEE Transactions on Magnetics, 2012
This paper investigates the axial carrying capacity of a new radial hybrid magnetic bearing (RHMB) using experimental, finite element, and magnetic circuit methods. The thrust bearing of traditional structures is not included because an axial resilience is generated by this new RHMB when the rotor is axially displaced.
Hou Eryong, Liu Kun
openaire   +1 more source

Residual Axial Bearing Capacity of Concrete-Filled Circular Steel Tubular Columns (CFCSTCs) after Transverse Impact

Applied Sciences (Switzerland), 2018
The purpose of this research is to study the effect of both transverse impact, and ratio of outer diameter to thickness of outer steel tube (D/t), on the residual axial bearing capacity of concrete-filled circular steel tubular columns (CFCSTCs). A total
Zhao Li, Guofeng Du, Xuemeng Bie
exaly   +2 more sources

Axial Compression of Footings in Cohesionless Soils. II: Bearing Capacity

Journal of Geotechnical and Geoenvironmental Engineering, 2009
An extensive database of full-scale field load tests was used to examine the bearing capacity for footings in cohesionless soils.
Kulhawy, Fred H., AKBAŞ, SAMİ OĞUZHAN
openaire   +2 more sources

Axial Compression Bearing Capacity Calculation of Hoop Reinforcement Concrete Column

Applied Mechanics and Materials, 2013
Concrete column in engineering need to increase the bearing capacity for various reasons, and requires the column section not to increase. In order to solve this problem, we start two tests of concrete column reinforced hoop and steel plate hoop reinforcement to propose the formula for calculating the bearing capacity, which can be used for reference ...
Jian Tang, Lang Wu, Na Xiong
openaire   +1 more source