Results 101 to 110 of about 134,890 (303)
Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann +3 more
wiley +1 more source
Experimental study on axial compression behavior of square pultruded GFRP tubular stub column
Case Studies in Construction MaterialsTo investigate the influence of aspect ratio and width-to-thickness ratio on the axial compression behavior of square pultruded glass fiber-reinforced polymer (GFRP) tubular stub columns, axial compression tests were conducted on 12 GFRP tubular columns.
Zhiquan Xing +5 more
doaj +1 more source
Nanomaterials, 2019 A series of hot compression tests at the temperature of 700 °C were applied to study the effect of the ultrasonic surface rolling process (USRP) on the hot compression behavior of Inconel 718 superalloy.
Zhiyan Sun, Shuai Ren, Timin Hu, Bo Li
doaj +1 more source
Nonlinear analysis of laminated fibrous composites [PDF]
A computerized analysis of the nonlinear behavior of fibrous composite laminates including axial loading, thermal loading, temperature dependent properties, and edge effects is presented.
Herakovich, C. T., Renieri, G. D.
core +1 more source
Advanced Engineering Materials, EarlyView.A hierarchical porous copper current collector is fabricated via three‐dimensional printing combined with pressureless sintering to stabilize lithium metal anodes. The interconnected architecture lowers local current density, guides uniform Li deposition within pores, and suppresses dendrite growth.
Alok Kumar Mishra, Mukul Shukla
wiley +1 more source
Triaxial compression tests on a crushable sand in dry and wet conditions [PDF]
, 2015 A calcareous sand from the Persian Gulf is subjected to a series of dry and fully drained saturated triaxial shear tests. The samples are prepared at relative densities of 65% and either left dry or saturated. They are consolidated to confining pressures
Haegeman, Wim, Van Impe, PO, Wils, L
core +1 more source
Anomalous compliance and early yielding of nanoporous gold
, 2015 We present a study of the elastic and plastic behavior of nanoporous gold in compression, focusing on molecular dynamics simulation and inspecting experimental data for verification.
Albe, Karsten +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Application of a PIP Slip Joint Consisting of Square Hollow Sections: A Numerical Approach
Journal of Marine Science and EngineeringThis study presents a numerical investigation into the structural behavior of a pile-in-pile (PIP) slip joint utilizing square hollow section (SHS) members, with a comparative assessment against conventional circular hollow sections (CHSs).
Md Ariful Islam +2 more
doaj +1 more source