Results 121 to 130 of about 1,050,413 (300)
The Financial Aspects behind Designing a Wind Turbine Generator
This article investigates the construction of a wind power generator requiring the lowest possible cost. The proposed model is an Axial Flux Permanent Magnet (AFPM) Synchronous Machine, which contains two iron rotors and a coreless stator between them ...
Alexandra C. Barmpatza +3 more
doaj +1 more source
Losses due to transverse flux in axial flux permanent magnet synchronous machines
A 2D and 3D non-linear and anisotropic FEM model at various frequencies and induction levels is used for calculating the iron losses in axial flux permanent magnet synchronous machines due to transverse magnetic flux (fringing flux).
Scheerlinck, Bart +5 more
core +1 more source
We describe detailed protocols for the purification and preparation of Marchantia polymorpha Auxin Response Factor 2 (MpARF2). This protein is fused to an MBP solubility tag and an mNG fluorescent tag and is purified from Escherichia coli. The presented procedures make it possible to study MpARF2 assemblies, which could arise from phase separation ...
Bas Janssen +5 more
wiley +1 more source
Proposal of Flux Concentrated Radial and Axial Magnetic Bearings
New flux concentrated hybrid (HB) type radial and axial magnetic bearings are proposed in this paper. It is intended to use ferrite permanent magnet (PM) for producing high bias flux.
Ryou Kondo +3 more
core +1 more source
Heterotropic regulation and negative homotropic cooperativity
We identified a structural module common to some proteins that couple negative cooperativity with heterotropic regulation, two features that rarely coexist. These proteins are ring‐like and present an ordered asymmetry whereby noncontacting subunits are symmetric, and their tertiary structure differs from that of contacting subunits.
Veronica Morea +5 more
wiley +1 more source
Thermofluid analysis of an axial flux permanent magnet (AFPM) generator [PDF]
CITATION: Wang, R., Dobson, R. T. & Kamper, M. J. 2001. Thermofluid analysis of an axial flux permanent magnet (AFPM) generator. R&D Journal, 17.ABSTRACT: In this article a lumped-parameter heat transfer model and an air flow model of a typical Axial ...
Kamper, M. J., Wang, R., Dobson, R. T.
core
Glioblastoma cells express calcitonin receptor variants (CT receptor isoforms) that may help them survive stress. Using qPCR, transcript‐specific long‐read nanopore sequencing, immunofluorescence co‐localisation and comparative sequence analysis, this study identifies a novel alternatively spliced CALCR transcript that encodes the CTb receptor isoform ...
Pragya Gupta +7 more
wiley +1 more source
Using peripheral blood for determining B‐cell or T‐cell clonality is more reliable when we use cell‐free RNA (cfRNA) because cells release blood significantly more RNA than DNA. Next‐generation sequencing (NGS) of cfRNA allows us to evaluate fragment cfRNA and evaluate clonality reliably without the need for prior determination of the specific dominant
Adam Albitar +11 more
wiley +1 more source
Comparative assessment of crystallographic and cryo‐EM models in the Protein Data Bank
Raw data obtained by X‐ray crystallography or cryo‐EM result in experimental maps, ultimately fitted by atomic models. Although the physical principles are different, the final results can be viewed, compared, and evaluated in the same way. With cryogenic electron microscopy (cryo‐EM) on track to surpass X‐ray crystallography as the preferred method ...
Alexander Wlodawer +7 more
wiley +1 more source
Design and Construction of a Multipole Electric Motor Using an Axial Flux Configuration
In the transportation industry, the use of renewable energies has been implemented in conjunction with the development of higher-power electric motors and, consequently, the development of intelligent control systems for torque and speed control ...
Adrián González-Parada +2 more
doaj +1 more source

