Results 91 to 100 of about 3,474,052 (202)

Thermofluid analysis of an axial flux permanent magnet (AFPM) generator [PDF]

, 2001
CITATION: Wang, R., Dobson, R. T. & Kamper, M. J. 2001. Thermofluid analysis of an axial flux permanent magnet (AFPM) generator. R&D Journal, 17.ABSTRACT: In this article a lumped-parameter heat transfer model and an air flow model of a typical Axial ...
Kamper, M. J., Wang, R., Dobson, R. T.
core  

Predictive Torque Control of Three Phase Axial Flux Permanent Magnet Synchronous Machines

Majlesi Journal of Electrical Engineering
This paper presents a predictive strategy to control torque and flux of an axial flux permanent magnet (AFPM) machine. Unlike conventional direct torque control (DTC) for permanent magnet machines that only six actives voltage vectors of inverter are ...
Mohsen Siami, S. Asghar Gholamian
doaj  

HIGH SPEED FUNCTIONALITY OPTIMIZATION OF FIVE-PHASE PM MACHINE USING 3RD HARMONIC CURRENT [PDF]

, 2013
This project was supported by the Laboratory of Electrical Engineering and Power Electronics (L2EP) France. It is a successive cooperation project between the control team and optimization team of the laboratory .Some surrogate-assisted optimization ...
GONG, Jinlin, ASLAN, Bassel, SEMAIL, Eric, GONG, Jilin, GILLON, Frédéric   +4 more
core  

Performance analysis and optimization of secondary U-shaped double-sided toroidal winding linear permanent magnet vernier machine

Engineering Science and Technology, an International Journal
Aiming at the issues of low thrust density, significant thrust ripple, the lengthy end and the large axial attraction force in conventional single-sided distributed winding linear permanent magnet vernier machine (LPMVM), this paper presents an enhanced ...
Xiaozhuo Xu, Sen Miao, Siyuan Jiang, Haichao Feng, Liwang Ai   +4 more
doaj   +1 more source

Electromagnetic Design Algorithm for Axial Flux Permanent Magnet Machines

IEEE Transactions on Energy Conversion
The interest in axial flux machines has grown in recent years because of their high power density. Considering their geometry, 3D or quasi-3D Finite Element (FE) models are necessary to simulate their behavior: the analysis of such models is time-consuming, and the iterations needed to derive the finaldesign may require long computation times.
Nicolo Gori, Claudia Simonelli, Antonino Musolino, Luca Sani, Rocco Rizzo, Hao Chen   +5 more
openaire   +1 more source

Projeto de motor de ímã permanente utilizando ferrite na configuração de ímãs enterrados [PDF]

, 2008
Dissertação (mestrado) - Universidade Federal de Santa Catarina, Centro Tecnológico. Programa de Pós-Graduação em Engenharia Elétrica.O objetivo deste trabalho foi propor um projeto alternativo para um motor de ímãs permanentes de 11 kW, na carcaça 132S,
Concer, Germano Esmeraldino
core  

Analysis of static and dynamic eccentricity faults in SSDR coreless axial flux permanent magnet machines. [PDF]

Sci Rep
Shahnazari M, Eslami F, Vaziri Sarashk ME, Vahaj AA.   +3 more
europepmc   +1 more source

A model predictive control framework with fatigue life assessment for flywheel energy storage systems supported by active magnetic bearings. [PDF]

Sci Rep
Hashim A, Shaltout ML, El-Kashif E, Hussein BA.   +3 more
europepmc   +1 more source

Multiphysics Investigation on Thermal Characteristics of Internal Bio-Inspired V-Ribbed Cooling Channels for Outer Rotor PMSM. [PDF]

Biomimetics (Basel)
Xiong X, Li X, You S, Zhu B, Ding P, Gao H, Hou Z.   +6 more
europepmc   +1 more source

TESCLA: A Fully Soft Electromagnetic Linear Actuator With Continuous Bending Enabled by Liquid-Metal Solenoids. [PDF]

Adv Mater
Choi Y, Kim J, Koh S, Park YL.
europepmc   +1 more source