Residual Stresses Induced by Dry and Cryogenic Cooling during Machining of AZ31B Magnesium Alloy [PDF]
, 2014 The major challenge of the Mg alloys has been their unsatisfactory corrosion resistance, which can be enhanced by improving the surface integrity. Cryogenic machining, where liquid nitrogen was used during machining, has been reported to improve the ...
MARQUES, Maria José +6 more
core
Stretch Press Bending of AZ31 Magnesium Alloy Extruded Square Tube [PDF]
, 2014 The results of the experimental study on bending behaviour of AZ31 magnesium alloy extruded square tube under stretch press bending are presented. Cracking with buckling occurs at compressive side, but we can bend AZ31 tube at room temperature by means ...
Murai, Tsutomu +2 more
core +1 more source
Finite element assisted prediction of ductile fracture in sheet bulging of magnesium alloys [PDF]
, 2008 There is currently a growing demand for energy efficiency, particularly in reducing the rate of oil consumption. One solution in this area is for the aerospace and automotive industries to produce lighter vehicles that are more fuel efficient.
Hunt, David
core +2 more sources
A Durability Prediction for the Magnesium Alloy AZ31 based on Plastic and Total Energy
Metals, 2019 Magnesium has a good strength-to-weight ratio. As a result, magnesium alloys are gradually becoming an integral part of lightweight designs that are especially important to the automotive and aerospace industries. The magnesium alloy AZ31 is particularly
Jernej Klemenc +2 more
doaj +1 more source
Microstructure and Strength Properties of AZ31 Mg Alloy Foams
, 2011 It is difficult to control the pore size and distribution of Mg alloy foam by melt foaming method using titanium hydride as blowing agent and extraordinary coarse pore structures is often found in the Mg alloy foams.
Bo Young Hur +3 more
core +1 more source
Crack behavior in Mg/Al alloy thin sheet during hot compound extrusion
Journal of Magnesium and Alloys, 2019 A novel and effective method to co-extrude metallic alloys is described which named Direct Extrusion and Bending-Shear Deformation. The compound extrusion plates have cracked at 290 °C and 3 mm/s.
Kun Sheng +4 more
doaj +1 more source
Influence of TiCN addition on the microstructures and mechanical properties of the AZ31 alloy. [PDF]
RSC Adv, 2022 Li QF +9 more
europepmc +1 more source
Enhancing Hydrogen Storage in AZ31 Alloy through Pd/G Composite [PDF]
, 2023 In this research, we investigated the catalytic effects of Palladium/Graphene(Pd/G) on AZ31 alloy for hydrogen storage. X-ray diffraction (XRD) analysis, scanning electron microscopy (SEM), and energy dispersive X-ray spectroscopy (SEM-EDS) were employed
Huang, Song-Jeng +3 more
core
Welding process of dissimilar metals controlled by PLC and it’s microstructure and properties
Results in Physics, 2018 The effects of welding current and welding speed on the forming, microstructure and mechanical properties of Q890D steel/AZ31 alloy dissimilar metal welded joints were studied, and the mechanism of welding parameters on the interface zone of Q890D steel ...
Shu Yufeng, Fan Sili, Xiong Changwei
doaj +1 more source
Intrinsic Effect of Pulsed Current on the Recrystallization of Deformed AZ31 Alloy. [PDF]
Materials (Basel), 2022 Wu J, Wang X.
europepmc +1 more source