Results 151 to 160 of about 54,948 (200)
Some of the next articles are maybe not open access.
Ballistic Pendulums and Dynamic Testing of Clays
Journal of the Geotechnical Engineering Division, 1979Ballistic pendulums provide simple and effective means of testing clays at constant rate of strain. Tests were performed at strain rates of 1,400%/sec and 2,300%/sec. Increasing stiffness of stress-strain response reported for lower strain rates (up to 0.17%/sec was found to occur for higher strain rates as well as for the horizontally oriented samples.
Farrokh N. Screwvala, Raj P. Khera
openaire +1 more source
BALLISTIC VALIDATION TESTING WITH CONFIDENCE SPECIFICATIONS
SAE Technical Paper Series, 2021<title>ABSTRACT</title> <p>Ballistic protection requirements often call out a minimum probability of no penetration against a projectile fired at a specified velocity with a required confidence level.
openaire +1 more source
On the determination of ballistic properties with ballistic test motors
20th Joint Propulsion Conference, 1984R. GLICK, W. BROOKS
openaire +1 more source
Development of a Sabot for Ballistics Testing
SAMPE 2022, 2022F. Solis +4 more
openaire +1 more source
JTCG/AS Interlaboratory Ballistic Test Program
1997Abstract : A two-phase study was conducted to determine the efficacy of MIL-STD-662E in ballistic protection limit determination for advanced lightweight armor technologies. The first-phase results demonstrated an unacceptable variability in limit estimates across sites.
Barry A. Bodt, Albert L. Chang
openaire +1 more source
Ballistic testing of B4C-Al cermets
1999The ballistic effectiveness of ceramic armor can be improved by improving the ductility, because this would increase the time duration of the erosion process where most of the projectile energy is dissipated. Increase in ductility can be obtained by mixing in some metallic phase into a ceramic.
Deutekom, M.J. +3 more
openaire +1 more source