Results 61 to 70 of about 37,387 (217)
Electronics LettersHere, based on thin film integrated passive device (TF‐IPD) technology, compact ultra‐wideband (UWB) bandpass filter (BPF) and dual‐band bandpass filter (DBBPF) with equal inductance configuration are proposed.
Zhi‐Hao Liu +3 more
doaj +1 more source
Realization of Electronic OTA Amplifiers with Linear and Tunable Transconductance and its Usages in Continuous - Filters [PDF]
Journal of Intelligent Procedures in Electrical Technology, 2012 The aim of this paper is the introduction of a CMOS OTA basic block that its transconductance gain can be electronically and linearly tuned. This transconductance is proportional to the square root of the bias current.
Ebrahim Borzabadi +2 more
doaj
Excitation Schemes of Plasmonic Angular Ring Resonator-Based Band-Pass Filters Using a MIM Waveguide
Photonics, 2019 This article describes the analysis and design of the excitation schemes of the plasmonic angular ring resonator-based band-pass filters using a metal-insulator-metal (MIM) waveguide.
Vishwanath Mittapalli, Habibulla Khan
doaj +1 more source
Annals of Clinical and Translational Neurology, EarlyView.ABSTRACT Chimeric antigen receptor (CAR) T‐cell therapy has been investigated in neurological diseases, encompassing both central nervous system malignancies and autoimmune disorders, thereby extending its application beyond hematological cancers.
Omar Alqaisi +5 more
wiley +1 more source
International Journal of Information and Communication Technology Research, 2014 In this paper, microwave filters were designed using dielectric layers, which were transversely located inside a partial H-plane waveguide. The proposed structure can be used to design microwave filters with arbitrary frequency response including band ...
Ali Ghajar, Habib Ghorbaninejad Foumani
doaj
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Deterministic Detection of Single Ion Implantation
Advanced Engineering Materials, EarlyView.Focused ion beam implantation with high detection efficiencies will enable the rapid and scalable fabrication of advanced spin‐based technologies such as qubits. This work presents the detection efficiencies of a wide range of ions implanted into solid‐state hosts, with efficiencies of >90% recorded for ion species and substrate combinations of ...
Mason Adshead +6 more
wiley +1 more source