Results 111 to 120 of about 19,593 (303)
The analysis of power quality disturbances in distribution systems has gained significance with the diffusion of electric vehicles (EVs). Waveform distortions are interesting since EV currents introduce distortions with spectral components in both low ...
Antonio Bracale +6 more
doaj +1 more source
Interphase chemistry governs the stability of multivalent metal batteries. We summarize state‐of‐the‐art developments in calcium and magnesium metal batteries by focusing on the correlation among electrolytes, interphase layers, and the electrochemical performance of corresponding metal anodes.
Huijun Lin +4 more
wiley +1 more source
Multi‐Scale Interface Engineering of MXenes for Multifunctional Sensory Systems
MXenes, as two‐dimensional transition metal carbides and nitrides, demonstrate remarkable capabilities for multifunctional sensing applications. This review systematically examines multi‐scale interface engineering approaches that enhance sensing performance, enable diverse detection functionalities, and improve system‐level compatibility in MXene ...
Jiaying Liao, Sin‐Yi Pang, Jianhua Hao
wiley +1 more source
Atomic Layer Deposition in Transistors and Monolithic 3D Integration
Transistors are fundamental building blocks of modern electronics. This review summarizes recent progress in atomic layer deposition (ALD) for the synthesis of two‐dimensional (2D) metal oxides and transition‐metal dichalcogenides (TMDCs), with particular emphasis on their enabling role in monolithic three‐dimensional (M3D) integration for next ...
Yue Liu +5 more
wiley +1 more source
This work introduces a regionally localized electrolyte (RLE) that spatially separates ether‐ and carbonate‐based functions to stabilize both Li metal and high‐voltage cathodes. An immobilized ether‐rich layer directs Li+ transport, activates LiNO3 locally, and forms a uniform LiF‐rich SEI, enabling lower overpotential, uniform deposition, and long ...
Eunbin Lim +4 more
wiley +1 more source
Joint optimization of bow-type fast charger locations and battery capacity for electric buses
The transition from fossil fuel-powered buses to battery electric buses (BEBs) is occurring gradually; however, BEBs encounter challenges such as limited driving range and extended charging durations, which highlight the need for the development of ...
Libing Liu +4 more
doaj +1 more source
Vehicle test report: Battronic pickup truck [PDF]
An electric pickup truck was tested to characterize certain parameters and to provide baseline data that can be used for the comparison of improved batteries that may be incorporated into the vehicle at a later time.
Freeman, R. J. +3 more
core +1 more source
Dielectric capacitors typically struggle to achieve both high energy storage density and high efficiency at applied voltages below 10 V. Here, we address this challenge by introducing a novel hybrid fluorite/perovskite heterostructure design that combines ultra‐high recoverable energy storage density with efficient energy release (Uf ≈ 1016 J/cm3), at ...
Ampattu R. Jayakrishnan +10 more
wiley +1 more source
In the realm of electric mobility, fast chargers for electric vehicles (EVs) play a critical role in mitigating range anxiety while driving. The converter in these chargers usually has a load profile consisting of a high-current pulse to swiftly recharge
Faezeh Kardan +2 more
doaj +1 more source
Final report: Workshop on: Integrating electric mobility systems with the grid infrastructure [PDF]
EXECUTIVE SUMMARY: This document is a report on the workshop entitled “Integrating Electric Mobility Systems with the Grid Infrastructure” which was held at Boston University on November 6-7 with the sponsorship of the Sloan Foundation.
Cassandras, Christos G. +2 more
core

