Results 261 to 270 of about 16,730,294 (301)

Sn‐Driven Grain Boundary Elimination for Single‐Crystalline Ni‐Rich Cathodes with Superior High‐Voltage Stability in Lithium‐Ion Batteries

open access: yesAdvanced Science, EarlyView.
A low‐temperature synthesis method of single‐crystalline NCA was successfully achieved by Sn doping, employing the same synthetic conditions as its polycrystalline counterparts. This synthesis was conducted at a temperature that was 150 °C lower than that required for synthesizing single‐crystalline NCA without Sn doping.
Guomeng Xie   +4 more
wiley   +1 more source

Embedded-Based Battery Management System using TinyML and IoT: A Review

open access: diamond
Disha Bhaskar Chaudhari   +3 more
openalex   +1 more source

Beyond Conventional: A Review of Phytochemical‐Hydrogel Systems Enhanced by AI and 3D Printing for Chronic Wound Management

open access: yesAdvanced Science, EarlyView.
This review systematically bridges chronic wound pathology with natural phytochemical hydrogel therapeutics. A pathology‐to‐phytochemical mechanistic mapping framework is established, linking specific wound hallmarks to targeted phytochemical interventions.
Yitao Zhou   +8 more
wiley   +1 more source

Temperature‐Modulated MEMS Gas Sensor Array Enabled by Physics‐Informed Deep Learning for Thermal‐Runaway Characteristic Gas Discrimination

open access: yesAdvanced Science, EarlyView.
This work presents a 2 × 2 integrated single‐chip MEMS gas sensor array with temperature modulation and deep learning for discriminating thermal‐runaway characteristic gases. The array generates distinct temperature‐modulated response patterns for four characteristic gases (H2, CO, CH4, and CO2), while a HK‐MoE model is developed to achieve robust ...
Qin Luo   +8 more
wiley   +1 more source

Active Cell Balancing Approach for Efficient Battery Management System

open access: diamond
Sadanand Harijan   +4 more
openalex   +2 more sources

Printing‐Assisted Integration of Thermal, Fluidic and Electrical Components in Implants for Focal Brain Cooling

open access: yesAdvanced Science, EarlyView.
Extrusion‐based 3D printing of silicones and discrete electronic components are combined to create cortical implants for rodents that integrate thermal neuromodulation and electrical recording. Linked to an autonomous auxiliary driver unit, the system enables rapid, stable and localized hypothermia alongside ECoG recording.
Spencer Ryan Moore   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy