Results 81 to 90 of about 143,496 (212)
Design charts for end-plate beam-to-column steel joints [PDF]
, 2017 The component method provided by Eurocode 3 for the evaluation of strength and stiffness of beam-to-column joints is considered a very laborious procedure that is often difficult to apply. This is owing to the large number of geometrical and mechanical
D'Alessandro, E. +2 more
core
Experimental response of RC columns built with plain bars under unidirectional cyclic loading [PDF]
, 2012 A large number of existing reinforced concrete (RC) buildings structures were designed and built before mid-70’s, when the reinforcing bars had plain surface and prior to the enforcement of the modern seismic-oriented design philosophies.
Costa, A. +3 more
core +1 more source
The stress distribution in the joints of vehicles chassis frames subject to torsion [PDF]
, 1978 The problem of warping inhibition in the joints, of commercial vehicle chassis frames is very important for the estimation. of stress distribution in the joints and the overall torsional stiffness of frames.
Alvi, M. S. I.
core
Seismic behaviour of reinforced concrete exterior wide beam-column joints [PDF]
, 2010 An experimental and numerical investigation carried out on RC wide beam-column joints when subjected to seismic loads is reported within this paper.
Li, Bing., Kulkarni, Sudhakar A.
core +1 more source
Monolithic Beam to Column Joints in Reinforced Concrete Buildings [PDF]
, 1986 A comprehensive study of monolithic beam-column joints in reinforced concrete buildings is presented. The design philosophy and the experimental investigations of beam-column joints are first reviewed, followed by a brief history of the finite element ...
Kesserwan, Ali M.
core
Diagonally-reinforced beam–column joints reinforced under cyclic loading [PDF]
, 2005 The beam-column joints in a reinforced concrete frame are vulnerable to damage caused by seismic events. The conventional detailing using transverse hoops usually results in serious joint congestion, which creates contruction problems.
Au, FTK, Huang, K, Pam, HJ
core +1 more source
Optimization of tensile strength of ferritic / austenitic laser welded components [PDF]
, 2008 Ferritic/Austenitic (F/A) joints are a popular dissimilar metals combination used in many applications. F/A joints are usually produced using conventional processes.
Anawa, E. +3 more
core +1 more source
Study of Seismic Behavior of RC Beam-Column Joints Strengthened by Sprayed FRP
Advances in Materials Science and Engineering, 2018 To study the seismic behavior of RC beam-column joints strengthened with sprayed FRP, five 1 : 2 reduced-scale specimens of joints were tested through quasi-static experiments. The failure modes, hysteretic curves, skeleton curves, strength, deformation,
Zhao Yang, Yong Liu, Jiajia Li
doaj +1 more source
Finite element for R.C. beam-column joints [PDF]
, 1995 In this paper a finite element of beam-column joint is presented, which is intended to be employed in the nonlinear seismic analysis of r.c. frames.
MONTI, Giorgio
core
Fracture and Structural Integrity, 2015 Beam-column joints which shoulders high-level and vertical shearing effect that maintains balance of beam and column end is the major component influencing the performance of the whole framework.
Wu Xu, Liu Ronggui
doaj