Results 101 to 110 of about 536,235 (301)
Imaging of Thermal Domains in ultrathin NbN films for Hot Electron Bolometers
, 2007 We present low-temperature scanning electron microscopy (LTSEM) investigations of superconducting microbridges made from ultrathin NbN films as used for hot electron bolometers.
Doenitz, D. +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source
Towards Defect Phase Diagrams: From Research Data Management to Automated Workflows
Advanced Engineering Materials, EarlyView.A research data management infrastructure is presented for the systematic integration of heterogeneous experimental and simulation data required for defect phase diagrams. The approach combines openBIS with a companion application for large‐object storage, automated metadata extraction, provenance tracking and federated data access, thereby supporting ...
Khalil Rejiba +5 more
wiley +1 more source
Design of a vertically stacked double Luneburg lens-based beam-scanning antenna at 60 GHz
Open EngineeringThis article presents the design of a 60 GHz beam-scanning antenna system with a coverage range of 50–100 m for high-speed indoor communication systems.
Alhumaidan Ahmed +4 more
doaj +1 more source
IEEE AccessThis article proposes a spoof surface plasmon polariton leaky-wave antenna (SSPP LWA) with independently suppressed open-stopband (OSB) and grating lobe for operation at millimeter-wave frequencies.
Ehsan Farokhipour +4 more
doaj +1 more source
Preliminary antenna design considerations for a STADAN relay satellite system [PDF]
Antenna design for multiple-beam, wide angle scanning phased array relay satellite ...
Gabriel, W. F.
core +1 more source
Realistic CT image simulation tools for laboratory based X-ray CT at UGCT [PDF]
, 2013 In laboratory based X-ray Computed Tomography (CT), the grey values in the resulting CT image depend on several scanning conditions such as the emitted spectrum, the response characteristics of the detector and beam filtration.
Brabant, Loes +3 more
core
, 2007 The focusing properties of three aspheric lenses with numerical aperture (NA) between 0.53 and 0.68 were directly measured using an interferometrically referenced scanning knife-edge beam profiler with sub-micron resolution.
B. G. Norton +9 more
core +1 more source
A Knowledge‐Based Approach for Understanding and Managing Additive Manufacturing Data
Advanced Engineering Materials, EarlyView.Additive manufacturing processes generate a large amount of data. Effectively managing, understanding, and retrieving information from this data remains a major challenge. Therefore, we propose an ontology‐based approach to integrate heterogeneous data, enable semantic queries, and support decision‐making.
Mina Abd Nikooie Pour +5 more
wiley +1 more source
Deterministic Detection of Single Ion Implantation
Advanced Engineering Materials, EarlyView.Focused ion beam implantation with high detection efficiencies will enable the rapid and scalable fabrication of advanced spin‐based technologies such as qubits. This work presents the detection efficiencies of a wide range of ions implanted into solid‐state hosts, with efficiencies of >90% recorded for ion species and substrate combinations of ...
Mason Adshead +6 more
wiley +1 more source