Results 101 to 110 of about 430,508 (214)
Surface profile changes of scuffed bearing surfaces [PDF]
A phase locked interference microscope capable of resolving depth differences to 30 A and planar displacements of 6000 A was constructed for the examination of the profiles of bearing surfaces without physical contact.
Fung, S. S. +2 more
core +1 more source
Nanostructured Bainitic Bearing Steel
ISIJ International, 2020 Zhinan Yang, Fucheng Zhang
openaire +2 more sources
Fire safety of steel wall systems using enhanced plasterboards [PDF]
, 2013 Fire safety design is important to eliminate the loss of property and lives during fire events. Gypsum plasterboard is widely used as a fire safety material in the building industry all over the world.
Frost, Ray +2 more
core +1 more source
Stresses in a webbed ball [PDF]
An experimental stress analysis was undertaken to evaluate stresses within cylindrically hollow reinforced webbed bearing balls proportioned for a 50 percent mass reduction.
Nypan, L. J.
core +1 more source
Decision Table Formulation of The 1969 Aisc Specification [PDF]
, 1969 The American Institute of Steel ...
Fenves, S.J. +2 more
core
Fracture-tough, corrosion-resistant bearing steels [PDF]
The fundamental principles allowing design of stainless bearing steels with enhanced toughness and stress corrosion resistance has involved both investigation of basic phenomena in model alloys and evaluation of a prototype bearing steel based on a ...
Olson, Gregory B.
core +1 more source
Age Hardening Characteristics of an Ultra-Low Carbon Cu Bearing Steel. [PDF]
Materials (Basel), 2020 Sun M, Xu Y.
europepmc +1 more source
Preliminary Research on Response of GCr15 Bearing Steel under Cyclic Compression. [PDF]
Materials (Basel), 2020 Zheng X, Zhang Y, Du S.
europepmc +1 more source
Multi-Dimensional Mathematical Wear Models of Vibration Generated by Rolling Ball Bearings Made of AISI 52100 Bearing Steel. [PDF]
Materials (Basel), 2020 Zmarzły P.
europepmc +1 more source
Spur-Gear-System Efficiency at Part and Full Load [PDF]
A simple method for predicting the part- and full-load power loss of a steel spur gearset of arbitrary geometry supported by ball bearings is described. The analysis algebraically accounts for losses due to gear sliding, rolling traction, and windage in ...
Anderson, N. E., Loewenthal, S. H.
core +1 more source