Results 211 to 220 of about 3,893,066 (230)
Some of the next articles are maybe not open access.

Poly(phenylacetylene)s bearing thianthrene groups as high-voltage organic cathode materials for lithium batteries

, 2020
Thianthrene-containing acetylenic monomers, thianthrene-1-ylmethyl 4-ethynylbenzoate (M1) and bis(thianthrene-1-ylmethyl)-4-ethynylphthalate (M2) were synthesized and polymerized with [(nbd)RhCl]2/Et3N catalyst to give polymers P1 and P2 with high ...
Juntao Ren   +5 more
semanticscholar   +1 more source

Experimental Investigation of Bearing Currents in Low Voltage Motors

International Conference on Electrical Machines, 2018
This paper deals with bearing currents phenomena in general and specifically for capacitive bearing currents in low voltage motors. With the technological advances in the automation field, new problems have also surfaced and bearing currents in small ...
K. Khan, F. Gyllensten
semanticscholar   +1 more source

Proposing the New Layered-Shield Structure for Shaft Voltage Reduction in IPMSM

IEEE Transactions on Transportation Electrification
As the era of electrification advances, the demand for increased power density and high efficiency in electric motors, such as those in electric vehicles (EVs) and e-mobility, has been rising.
Jun-Hyeok Heo   +3 more
semanticscholar   +1 more source

Electric damage of bearing under AC shaft voltage at different rotation speeds

Tribology International, 2022
Kai Niu   +6 more
semanticscholar   +1 more source

A Novel Nonintrusive Measurement Method of Bearing Currents in Inverter-Fed Motors

IEEE Sensors Journal
Electrical erosion caused by bearing currents is one of the main reasons for bearing failure in inverter-fed motors. The research of nonintrusive measurement of bearing currents contributes to risk assessment and early warning of bearing electrical ...
Zhihao Li   +4 more
semanticscholar   +1 more source

Development of a Noncontact Measurement Setup for the Evaluation of Bearing Voltages

IEEE Sensors Journal
The damage resulting from bearing voltages is a major cause of premature machine failures. The necessary measurements at the system level and installed conditions can be difficult to perform with conventional measurement systems.
Daniel Proksch   +4 more
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy