Results 11 to 20 of about 260 (170)
A novel consequent‐pole bearingless PMSM with integrated winding for flywheel energy storage
Generating torque and suspension force with one set of windings at the same time can increase the copper space factor and improve the torque output capacity.
Jie Xu +4 more
doaj +2 more sources
A 5‐degrees of freedom hybrid excitation bearingless motor for vehicle flywheel battery
To deal with the restriction of vehicle space on a flywheel battery, a 5‐degrees of freedom (DOF) hybrid excitation bearingless motor (HEBM) was proposed. The 5‐DOF suspension force required for the flywheel battery is provided by HEBM.
Fan Yang +3 more
doaj +2 more sources
Design and analysis of double 6/3 transverse flux bearingless switched reluctance motor
A novel dual 6/3 Transverse Flux Bearingless Switched Reluctance Motor is proposed to solve the coupling problem between torque and suspension of conventional Switched Reluctance Motor. The working principle is introduced in detail, the motor is modelled
Kai Xie +5 more
doaj +2 more sources
Electromagnetic design of an ultra‐high‐speed bearingless permanent magnet synchronous motor
Aiming at the problem of high‐speed motors being limited by multiple physical fields, which makes it difficult to achieve ultra‐high‐speed stable operation and develop towards higher speeds and higher power, an ultra‐high‐speed bearingless permanent ...
Wang Xiaoyuan +3 more
doaj +2 more sources
Bearingless motors can realise the rotor active suspension by the radial electromagnetic force, whereas the suspension force and torque ripple will increase the difficulty of motor control, which may lead to the stator and rotor collision and ...
Zexing Li +3 more
doaj +2 more sources
Abstract In this paper, a strategy of integrating direct‐drive turbine compressors with high‐speed permanent magnet external rotor motors is used to improve the problems of large footprint, low efficiency and high maintenance costs. The rotor of the motor will vibrate under the action of radial electromagnetic force when rotating, and under the action ...
XiaoYuan Teng +4 more
wiley +1 more source
Abstract Robust cell retention devices are key to successful cell culture perfusion. Currently, tangential flow filtration (TFF) and alternating tangential flow filtration (ATF) are most commonly used for this purpose. TFF, however, suffers from poor fouling mitigation, which leads to high filtration resistance and product retention, and ATF suffers ...
Maria E. Weinberger +2 more
wiley +1 more source
The cell separation process is one of the key elements in biopharmaceutical productions. In the last years, some new devices were launched by different manufacturers. In this work, the novel single‐use disk stack separator kytero 500 from GEA was successfully used for the separation of antibody producing Chinese hamster ovary cells. Abstract Single‐use
Vivian Ott +8 more
wiley +1 more source
Super‐spiral sliding mode controller design for single‐winding bearingless switched reluctance motor
Abstract The strong coupling effect between the torque system and the suspension system of the single‐winding bearingless switched reluctance motor (SWBSRM) would result in continuous interference to the system and bring difficulties to the design of the control system.
Kai Xie +5 more
wiley +1 more source
Abstract The performance of flywheel battery is affected by the vibration and friction of traditional mechanical bearing. A novel kind of bearingless brushless direct current machine (BBLDCM) with the hybrid capabilities of electrical machine and suspension is suitable for flywheel battery which reduces the losses and improves the power quality.
Yichen Liu, Huangqiu Zhu, Bo Xu
wiley +1 more source

