Results 1 to 10 of about 145,956 (209)
Applied Sciences, 2022 Belt transmission is one of the most common forms of transmission on CNC lathes. To assess the impact of belt performance on monitoring machining conditions using motor current signal analysis, we developed a dynamic model for belt-driven ...
Zhexiang Zou +5 more
doaj +1 more source
Torques and Moments of Inertia Models for Horizontal Axis Hydrokinetic Turbine Driveline
Trends in Computational and Applied Mathematics, 2023 The quantification of torques and moments of inertia of horizontal axis hydrokinetic turbine driveline is important to precisely predict the dynamic behavior of the complete system.
M. H. C. Bentes +5 more
doaj +1 more source
Chinese Journal of Mechanical Engineering, 2021 The noncircular synchronous belt drive mechanism has demonstrated certain achievements and has been used in special fields. Research regarding noncircular synchronous belt drive mechanisms has focused on optimization design and kinematic analysis in ...
Jianneng Chen +4 more
doaj +1 more source
Development trends in belt transmissions with V-belt
MATEC Web of Conferences, 2022 The continuous increase in the use of the transmissions with V-belt, the introduction of new materials for the production of belts and the development of new manufacturing techniques have become the reason for undertaking research works on the possibilities of increasing the load capacity and durability of belts as well as reducing their influence on ...
Piotr Krawiec +3 more
openaire +2 more sources
From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives : influence of tensioner and belt characteristics [PDF]
, 2009 Serpentine belt drives are often used in front end accessory drive of automotive engine. The accessories resistant torques are getting higher within new technological innovations as stater-alternator, and belt transmissions are always asked for higher ...
Dufour, Regis +3 more
core +3 more sources
Principle and Error Analysis of Non-circular Steel Belt Transmission
Jixie chuandong, 2022 Aiming at the problem that the transmission ratio error of a steel belt transmission device in a flexible base is large, the transmission principle and transmission law of the steel belt transmission device are analyzed. Firstly, the non-circular profile
Deng Xu, Yuan Ye, Zhang Kai, Wu Qingwen
doaj
Justification, Legitimacy, and Administrative Governance [PDF]
, 2005 Richard Stewart, in his classic article ‘The Reformation of American Administrative Law,’ argues that the demise of the ’transmission belt’ model of administrative governance creates a crisis of agency legitimacy, and he skeptically surveys a range of ...
Adler, Matthew D.
core +2 more sources
Design and fabrication of a simple pedal operated cassava grater suitable for rural dwellers
Journal of Applied Sciences and Environmental Management, 2019 Food crop in Nigeria is mainly produced by farmers in the rural areas where petrol/diesel for operating engine, electricity and machines for processing agricultural produce are lacking and this usually result to loss of agricultural produce on the farm ...
K.O. Yusuf, T.D. Akpenpuun, M.O. Iyanda
doaj +1 more source
Relativistic microburst storm characteristics: Combined satellite and ground-based observations [PDF]
, 2010 We report a comparison of Solar Anomalous Magnetospheric Particle Explorer detected relativistic electron microbursts and short-lived subionospheric VLF perturbations termed FAST events, observed at Sodankyl Geophysical Observatory, Finland, during 2005.
Bortnik, Jacob +4 more
core +1 more source
The experimental study and numerical simulation of falling liquid film flow on horizontal tubes [PDF]
, 2014 This research is motivated by two observations: No report has been found so far in studies of water falling film up to 100 mm intertube spacing. No simulation analysis of film thickness under influence of intertube spacing in 3 dimensional models ...
Abdul Rahim, Ruzairi +10 more
core +3 more sources