Results 21 to 30 of about 14,842 (144)
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2020 Some studies have shown that offset toothed double helical synchronous belts (OTDHSB) have lower transmission noise and higher fatigue life than straight toothed synchronous belts (STSB).
Jianhua GUO +4 more
doaj +1 more source
Polish Polar Research, 2020 The Munin River (Svalbard) is a mountainous braided proglacial river. It drains from two valley glaciers developing an elongated channel belt and turning into a wide braided outwash fan before entering the main river.
Ondráčková Lenka +2 more
doaj +1 more source
Non-reloading coal transportation in the eastern inclined shaft of “Raspadskaya” mine [PDF]
E3S Web of Conferences, 2021 The planned increase in the mine output from 6.5 to 13.6 million tons per year has set the task of reconstructing a conveyor transport in the eastern inclined shaft of the Raspadskaya mine.
Yurchenko Vadim, Nesterov Valeriy
doaj +1 more source
Lateral motion of a flat belt in an open-end belt system with in-plane misalignment
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2023 Belt systems with flat belts and rollers have been widely used in power transmission and article transport mechanisms. In belt systems, the relative tilt of adjacent rollers, called misalignment, causes the flat belt to move in the width direction ...
Kazushi YOSHIDA, Shoma TAKEDA
doaj +1 more source
Improving the accuracy of determining the width of the load carrier conveyor belts based on detailing cross-sectional area factors [PDF]
Научно-технический вестник Брянского государственного университетаDetermining the width of the load-bearing belt of a conveyor belt is one of the basic design procedures that directly affect the further synthesis of geometric parameters of the entire conveyor. During this procedure, engineers are forced to operate with
Goncharov K.A. +2 more
doaj +1 more source
Belt conveyor deviation and coal stacking monitoring method based on three-dimensional point cloud
Gong-kuang zidonghua, 2022 Conveyor belt deviation and coal stacking are common faults of belt conveyor in the coal mine. The traditional contact conveyor belt deviation or coal stacking detection methods can not meet the requirements of coal mine safety production in terms of ...
XU Shichang +5 more
doaj +1 more source
Trudy Universiteta, 2023 The article presents the research work carried out in the field of conveyor transport. The analysis of the calculation scheme for the calculation has been carried out according to the theory of flexible thread. The width of the conveyor rubber-tether belt has been implemented in mathematical modeling of optimization of cable arrangement.
Oyum BALABAYEV +4 more
openaire +1 more source
Vegetation impact on the drag coefficient and resistance of trees against shore waves [PDF]
علوم و مهندسی آبیاری, 2015 Effect of the shore green belt on reduction of wave height and energy of the attacking waves is studied. Experiments are conducted for two patterns, triangular spaced 5 × 5 and 10 × 10 cm, 3 width of 10, 30 and 40 cm, 5 shore slopes of 0, 3, 5, 7 and 10%
Elham Ghanbari Adivi +1 more
doaj +1 more source
ASSESSING MEANDER BELT WIDTH OF BHAGIRATHI-JALANGI RIVER SYSTEM IN LOWER GANGA DELTA, INDIA
European Journal of Geography, 2020 The present work is an attempt to assess the meander belt width of the river Bhagirathi (frequently oscillating) and river Jalangi (relatively stable) in West Bengal, India based on geospatial data and field data (lithological composition and flow ...
Aznarul ISLAM +3 more
doaj +2 more sources
Fault zone trapped waves at Longmenshan fault belt
Geodesy and Geodynamics, 2013 Trapped waves in different sections of Longmenshan fault belt were observed, and the results show the difference between the northern and southern portions of this fault belt.
Sun Yi, Lai Xiaoling
doaj +1 more source