Results 51 to 60 of about 47,611 (264)
IPMC Based Biosensor for the Detection of Biceps Brachii Muscle Movements
International Journal of Electrochemical Science, 2013 Ionic polymer-metal composite (IPMC) consists of a polyelectrolyte film both-surfaces plated by metallic electrodes. When the IPMC bends, a voltage is generated between the two electrodes across the membrane.
Kiwon Park +6 more
doaj +1 more source
Improved model for correcting the ionospheric impact on bending angle in radio occultation measurements [PDF]
Atmospheric Measurement Techniques, 2018 The standard approach to remove the effects of the ionosphere from neutral atmosphere GPS radio occultation measurements is to estimate a corrected bending angle from a combination of the L1 and L2 bending angles.
M. J. Angling, S. Elvidge, S. B. Healy
doaj +1 more source
Remote Sensing, 2023 In this work, a dedicated campaign by MetOp-A satellite is conducted to monitor the ionosphere based on radio-occultation (RO) measurements provided by the onboard GNSS (Global Navigation Satellite System) Receiver for Atmospheric Sounding (GRAS).
Fabricio S. Prol +7 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Sensors, 2020 This paper presents a method to integrate and package an accelerometer within a textile to create an electronic textile (e-textile). The smallest commercially available accelerometer sensor (2 mm × 2 mm × 0.95 mm) is used in the e-textile and is fully ...
Menglong Li +6 more
doaj +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Fashion and Textiles, 2022 As the global population ages, there is an increasing demand for physical assistive devices for the elderly. This study aimed to develop and evaluate a wearable gripping aid for elderly women to assist in their handgrip ability.
Soo-Min Lee +3 more
doaj +1 more source
Performance Analysis of Abradable Coating Systems for Aircraft Gas Turbines
Advanced Engineering Materials, EarlyView.Three CoNiCrAlY/YSZ/MgAl2O4 abradable liner configurations on a nickel‐superalloy are evaluated by thermal‐gradient cycling and incursion tests. Laser ablation of the bondcoat and/or Y2O3‐stabilized ZrO2 (YSZ) intermediate layer increases mechanical interlocking and bonding for thick topcoats.
Hanna Heyl +4 more
wiley +1 more source
Firat University Journal of Experimental and Computational EngineeringThis study aims to evaluate the stress distribution of nickel-titanium (Ni-Ti) rotary tools with different conical angles during bending and torsion using finite element analysis (FEA).
Mehmet Eskibağlar, Serkan Erdem
doaj +1 more source
Advanced Engineering Materials, EarlyView.Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source