Results 271 to 280 of about 1,161,291 (313)
Some of the next articles are maybe not open access.
International Journal of Metals, 2020
M. Zolfaghari, M. Azadi, M. Azadi
semanticscholar +1 more source
M. Zolfaghari, M. Azadi, M. Azadi
semanticscholar +1 more source
Rotating-Beam Reversed-Bending Fatigue Curves
2004Abstract This data set contains the results of rotating-beam reversed-bending fatigue tests for a wide range of aluminum casting alloys. These fatigue curves are the results of tests on individual lots of material considered representative of the respective alloys and tempers.
openaire +1 more source
SINGLE TOOTH GEAR BENDING FATIGUE TEST
2017<div class="section abstract"> <div class="htmlview paragraph">This SAE Recommended Practice defines the set-up and procedure for conducting the SAE Single Tooth Bending Fatigue Test. The details of the test fixture to be used (referred henceforth as “the test fixture” in this document) and gear test sample and the procedures for testing ...
openaire +1 more source
Fatigue behavior of SFRC under Bending
2012The aim of the present work was to investigate the post-peak cyclic behavior of Steel Fiber Reinforced Concrete (SFRC) under bending by means of an experimental campaign. The effects of two different volume fraction of fibers (0.5% and 1.0%) and three different load levels have been considered and the fatigue performances of plain and SFRCs are ...
GERMANO, Federica, PLIZZARI, Giovanni
openaire +1 more source