Distinct Structural Determinants of Failure in Morse Taper and Internal Hex Implant Systems. [PDF]
Gehrke SA +7 more
europepmc +1 more source
A Distributed 4-Port Hilbert Slot MIMO Antenna with Full-Body Phantom Validation for mmWave Wearable Telemetry. [PDF]
Saleh S, Saeidi T, Timmons N.
europepmc +1 more source
A Compact Dual-Port Dual-Polarized Ultrawideband Wearable Textile Antenna for Off-Body Communications in IoT-Based WBAN Scenarios. [PDF]
Guo K, Gao X, Tang W, Bu X, An J.
europepmc +1 more source
High-Strength Steel in Civil Engineering Structures: A Review of Material Behaviour, Durability, Fatigue and Component Performance. [PDF]
Ding Z +5 more
europepmc +1 more source
Decoding Multidimensional Machining Loads: iKIT Wireless Extrasensory Toolholder and Parametric Analysis in Aluminum Cutting. [PDF]
Qiao Q, Guo D, Kwok CT, Tam LM.
europepmc +1 more source
Experimental Investigation on Flexural Behavior of Reinforced Concrete Beams with Externally Applied Liquid Rubber. [PDF]
Ouyang Q, Liang X, Lan L, Zhu W, Zhou X.
europepmc +1 more source
Related searches:
A 66-year-old African American man presented with episodic transient visual loss triggered by bending forward. The initial examination did not suggest intraocular pathology and the patient was nearly sent for vascular evaluation given his cardiovascular risk factors.
Michele D. Lee +4 more
openaire +2 more sources
Holey Fibers for Low Bending Loss
IEICE Transactions on Electronics, 2006We have developed a novel type of holey fiber which has a conventional raised-index core surrounded by two layers of air holes with different sizes. The fiber has single-mode operation and shows a low bending loss even for an extremely small bending diameter and a low splicing loss for fusion splicing to a conventional single-mode fiber.
Ning Guan +5 more
openaire +1 more source
Low-loss semiconductor waveguide bends
Optics Letters, 1988An experimental comparison is made between the losses of waveguide bends in disorder-delineated waveguides in semiconductor superlattices composed of GaAs and AlAs layers for simple abrupt bends and abrupt bends with an additional half-angle guiding wall proposed by Shiina et al. [Opt. Lett. 11, 736 (1986)].
P D, Swanson +6 more
openaire +2 more sources
Pressure losses in microchannels with bends
Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090), 2002Bends in fluidic systems are necessary features due to design or technology constraints. Bends or curves in a duct always induce flow separation at the walls, which results in additional pressure loss. In this work, this phenomenon is investigated on a microscale.
S. Yuk Kwan Lee, M. Wong, Y. Zohar
openaire +1 more source

