Results 101 to 110 of about 52,029 (359)
Flexural behaviour of ferrocement. [PDF]
, 1982 Ferrocement is often believed to be a form of reinforced concrete. However, in spite of the similarities between the two materials there are still major differences, indicating that ferrocement requires a separate study to establish its structural ...
Alwash, Abdul Salam A
core
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Theoretical Model of Bending Moment for Straight Mortise-and-Tenon Joints with Wooden Pegs Involving a Gap. [PDF]
Materials (Basel), 2022 Hu B, Cai J, Yang C.
europepmc +1 more source
Distribution of vertical displacement and bending moment obtained from different methods: (a) Vertical displacement; (b) Bending moment.
Zhenbo Zhang (579190) +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.Composite Ti–6Al–4V–epoxy lattice structures are additively manufactured and epoxy infiltrated for cyclic loading. At low lattice volume fractions, hybridization produces synergistic gains in stiffness and energy dissipation. At higher volume fractions, synergy diminishes, although composites still exceed metallic lattices in specific energy ...
Joey Tallon +3 more
wiley +1 more source
A New Hypersonic Wind Tunnel Force Measurement System to Reduce Additional Bending Moment and Avoid Time-Varying Stiffness. [PDF]
Sensors (Basel), 2022 Li S, Liu Z, Zhao F, Gao H.
europepmc +1 more source
Moving force identification from bending moment responses of bridge
, 2002 Moving force identification is a very important inverse problem in structural dynamics. Most of the identification methods are eventually converted to a linear algebraic equation set.
Yu, L +3 more
core
Plastic collapse of pipe bends under combined internal pressure and in-plane bending
, 2005 Plastic collapse of pipe bends with attached straight pipes under combined internal pressure and in-plane closing moment is investigated by elastic–plastic finite element analysis.
Robertson, A.C., Mackenzie, D., Li, H.
core +1 more source
From Shear to Sound: Mechanics–Acoustics Mapping of TPMS Lattices
Advanced Engineering Materials, EarlyView.Triply periodic minimal surface (TPMS) lattices are mapped across mechanical and acoustic performance, revealing that descriptors validated in compression fail under shear. First‐time comparison with trusses included. A transition from porous to resonance‐driven absorption emerges at 25% density.
Lucía Doyle +3 more
wiley +1 more source
Strain diagrams of cross-section of reinforced concrete bending elements
Tehnički Glasnik, 2017 The article is dedicated to the construction of the "bending moment – curvature" diagrams for rectangular cross-sections of reinforced concrete bending elements.
Anatolii Kovrov +2 more
doaj