Review of Creep Cavitation and Rupture of Low Cr Alloy and its Weldment [PDF]
, 2013 This paper presents a review of creep cavitation and rupture of low Cr alloy and its weldment, particular in the heat-affected zone (HAZ). Creep damage is one of the serious problems for the high temperature industry.
Xu, Qiang +6 more
core +1 more source
TEM characterisation of near surface deformation resulting from lubricated sliding wear of aluminium alloy and composites [PDF]
, 2007 Aluminium alloy composites have been extensively investigated for use in tribo-contact applications, however little detailed literature exists on the sub-surface microstructural evolution as a result of lubricated sliding wear.
Rainforth, W.M. +7 more
core +1 more source
Influence of oxide films on primary water stress corrosion cracking initiation of alloy 600 [PDF]
, 2006 In the present study alloy 600 was tested in simulated pressurised water reactor (PWR) primary water, at 360 °C, under an hydrogen partial pressure of 30 kPa. These testing conditions correspond to the maximum sensitivity of alloy 600 to crack initiation.
Panter, J. +6 more
core +1 more source
Sintering behaviour of cupronickel alloy powder
, 1976 Studies have been made of both the solid state and supersolidus sintering characteristics of spherical cupronickel powders. Observations were made of the structural changes and shrinkage rates in specimens sintered in vacuum and in hydrogen.
Bala, Sathish Rao
core +1 more source
A predictive fatigue life model for anodized 7050 aluminium alloy [PDF]
, 2013 The objective of this study is to predict fatigue life of anodized 7050 aluminum alloy specimens. In the case of anodized 7050-T7451 alloy, fractographic observations of fatigue tested specimens showed that pickling pits were the predominant sites for ...
Chaussumier, Michel +4 more
core +1 more source
The influence of laser assistance on the machinability of the titanium alloy Ti555-3 [PDF]
, 2013 The Ti533-3 alloy is a new titanium alloy which is starting to see increased use in the aeronautical domain to improve the durability of components and to optimize the weight/resistance ratio. This alloy is characterized by greater resistance compared to
GERMAIN, Guénaël +3 more
core +1 more source
Cyclic voltammetric studies on the electrochemical behaviour of cupronickel in sodium chloride solution [PDF]
, 2002 The electrochemical behavior of the dissolution of cupronickel in aqueous sodium chloride solutions was investigated through cyclic voltammetric and X-ray diffraction studies.
Palaniswamy, N. +2 more
core
Lubricated sliding wear behaviour of aluminium alloy composites
, 2005 Interest in aluminium alloy (Al-alloy) composites as wear resistant materials continues to grow. However, the use of the popular Al-alloy-SiC composite can be limited by the abrasive nature of the SiC, leading to increased counterface wear rates.
Rainforth, W.M., Jones, H., Walker, J.C.
core +1 more source
Impact of Ammonia Producing Bacillus sp. on Corrosion of Cupronickel alloy 90:10
, 2009 The objectives of the present investigation were to characterize ammonia-producing bacteria (Bacillus sp.) and study its impact on biodeterioration of cupronickel alloy 90:10. in a nitrogen free environment.
Bae, J.H. +8 more
core +1 more source