Results 331 to 340 of about 6,442,831 (407)

Management of sacroiliac joint pain: current concepts. [PDF]

open access: yesEur J Orthop Surg Traumatol
Migliorini F   +5 more
europepmc   +1 more source

Influence of an Al‐Doped ZnO Interface Layer on the Thermochromic Properties of VO2 Thin Films Deposited by RF Magnetron Sputtering

open access: yesAdvanced Engineering Materials, EarlyView.
Herein the metal‐to‐insulator transition is investigated when depositing vanadium dioxide (VO2) on glass or aluminum‐doped zinc oxide (AZO). O2 flow tuning during the deposition and additional post annealing are effective to control the metal‐to‐insulator transition. However, the VO2/AZO/glass stack reveals an increase in the transition temperature and
Eduard Llorens Balada   +3 more
wiley   +1 more source

X‐Ray Computed Tomography Quantifies Primary Phases and Reveals Crack Morphology in High‐Cycle Fatigue of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
Primary phases and a fatigue crack are studied in a forged blank of an aluminum alloy using synchrotron and laboratory X‐ray computed tomography. To image the crack, the fatigue test is interrupted, and a static tensile load is applied to open the crack.
Jakob Schröder   +6 more
wiley   +1 more source

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

open access: yesAdvanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk   +4 more
wiley   +1 more source

Development of a novel extension of Rayleigh distribution with application to COVID-19 data. [PDF]

open access: yesSci Rep
Qayoom D   +8 more
europepmc   +1 more source

Scalable Manufacturing of Radiation‐Tolerant Potentiometric Electrodes: A Systematic Transition from Laboratory to Semiautomated Fabrication

open access: yesAdvanced Engineering Materials, EarlyView.
Laboratory protocols for producing thin‐film pH electrodes for sterilized single‐use technologies have been successfully developed into a semiautomated workflow, with higher throughput and precision of membrane thickness. Accuracies are within 0.05 pH units versus ground truth, and uncertainty analysis reveals the largest sources of error to be derived
Bingyuan Zhao   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy