Results 41 to 50 of about 990,915 (186)
Operation of the full‐bridge three‐level DC–DC converter in unbalanced bipolar DC microgrids
As compared to two‐wire, unipolar DC microgrids (DCμGs), bipolar DCμGs apply a positive, neutral and negative conductor to increase the power transfer capability while retaining two voltage levels for supplying low‐ and high‐power devices at an appropriate voltage.
Van den Broeck, Giel +4 more
openaire +2 more sources
Modeling and Control of a Bipolar DC-DC Boost Converter for Bipolar DC Microgrids
Bipolar direct current (DC) microgrids have emerged as a promising alternative for efficiently integrating of renewable energy sources. However, these systems are susceptible to voltage imbalance between the positive and negative poles, especially with asymmetric loads.
Miréli B. Vendruscolo +4 more
openaire +2 more sources
Linearised Bipolar Power Flow for Droop-controlled DC Microgrids
The increase in efficiency and easiness to connect renewable energy sources has brought an increased interest into DC microgrids. Bipolar DC microgrids, present advantages over unipolar DC microgrids. Yet, due to their configuration they are prone to suffer from asymmetric loading which results in voltage unbalances among poles.
Vasquez Mayen, Eduardo Rene +1 more
openaire +1 more source
Novel solar PV-fuel cell fed dual-input-dual-output dc-dc converter for dc microgrid applications
In this paper, a new dual-input-dual-output (DIDO) dc-dc converter is proposed to interface solar PV and fuel cell (FC) sources to a low-voltage dc microgrid.
Agarwal, Vivek +3 more
core +1 more source
DC microgrid with DRES, BESS, AC/DC converter and load.
DC microgrid with DRES, BESS, AC/DC converter and load.
Muhammad Aamir (5559917) +4 more
core +1 more source
A Comprehensive Review of Fault‐Current Limiter Technologies for Smart and Resilient Power Systems
This review compares superconducting, solid‐state, and hybrid fault‐current limiters (FCLs) for modern alternating current, direct current, and hybrid grids. It shows that optimal FCL selection depends on fault characteristics, network configuration, voltage level, protection coordination, and resilience requirements rather than on a universally ...
Abdelrahman Farghly +5 more
wiley +1 more source
ABSTRACT A new‐type power system serves as a critical technical support for the integration of new energy, and its secure and stable operation is of great importance. However, the extensive utilisation of power electronic devices leads to power equipment insulation being subjected to electrical stresses of high‐frequency harmonics, which can easily ...
Shengtao Li +4 more
wiley +1 more source
This Perspective summarizes grid‐scale electrochemical energy storage research at Pacific Northwest National Laboratory, focusing on cost‐competitive battery development, reliability and safety validation, and grid‐duty‐cycle relevance. By integrating technology development with deployment‐oriented considerations, it outlines pathways toward reliable ...
Xiaolin Li +27 more
wiley +1 more source
Direct current (DC)–DC converters are the backbone of electric vehicle (EV) power trains, enabling efficient and bidirectional energy flow between the battery, high‐voltage (HV) DC link, and auxiliary rails under tight isolation, gain, ripple, and electromagnetic interference (EMI) constraints.
Abhilash Sakhare +3 more
wiley +1 more source
This paper introduces a novel mDCX that incorporates small‐capacity embedded power flow control modules (PFCMs) with bidirectional power flow regulation capability. The integration of PFCMs enhances the system's capability for port expansion, significantly reducing cost and physical footprint.
Yajun Jia +6 more
wiley +1 more source

