Results 231 to 240 of about 7,168,348 (289)
Some of the next articles are maybe not open access.
Bit error rates for general beams
Applied Optics, 2008In order to analyze the effect of beam type on free space optical communication systems, bit error rate (BER) values versus signal-to-noise ratio (SNR) are calculated for zero order and higher order general beam types, namely for Gaussian, cos-Gaussian, cosh-Gaussian, and annular beams.
Serap Altay, Arpali +2 more
openaire +2 more sources
Sequential Bayesian Bit Error Rate Measurement
IEEE Transactions on Instrumentation and Measurement, 2004As bit error rates decrease, the time required to measure a bit error rate (BER) or perform a BER test (i.e., to determine that a particular communications device's BER is less than some acceptable limit) increases dramatically. One cause of long measurement times is the difficulty of deciding a priori how many bits to measure to establish the BER to ...
openaire +1 more source
Jitter Effects on Bit Error Rate Reexamined
IEEE Transactions on Communications, 1981Standard references show the effects of carrier phase jitter on the performance of digital communications equipment as curves of bit error rate versus signal-to-noise ratio for constant values of jitter variance. In any real system, the variance consists of a relatively small constant component and a component which is inversely proportional to signal ...
Larry C. Schooley, G. R. Davis
openaire +2 more sources
2001
A practical consideration that has so far received little attention is the correcting power of the coding required to do the job. In other words, if we need a certain improvement in channel performance, how many bits must we be able to correct? This aspect of the subject gets quite mathematical, so I shall give only a simplified view of the problem in ...
openaire +1 more source
A practical consideration that has so far received little attention is the correcting power of the coding required to do the job. In other words, if we need a certain improvement in channel performance, how many bits must we be able to correct? This aspect of the subject gets quite mathematical, so I shall give only a simplified view of the problem in ...
openaire +1 more source
Convolutional Encoders to Minimize Bit‐Error‐Rate
European Transactions on Telecommunications, 2000AbstractThe results of a computer search for convolutional encoders for the binary symmetric channel and the additive white Gaussian noise channel are reported. Both feed‐forward and feedback encoders are considered. It is shown that, when bit error rate is the design criterion.
Amos Lapidoth, Peter J. Sallaway
openaire +1 more source
On Monte Carlo Simulation of the Bit Error Rate
2011 IEEE International Conference on Communications (ICC), 2011Simulation, point estimation, and interval estimation of the bit error rate are rigorously examined. Exact confidence intervals based on the F-distribution approximation for the binomial and negative binomial distributions are derived. Simulations demonstrate 1) that the analysis gives accurate confidence intervals for bit error rate estimators and 2 ...
Brian A. Mazzeo, Michael Rice
openaire +1 more source
Bit error probabilities in a two-rate communication system
IEEE International Conference on Communications, 2003. ICC '03., 2004We examine a two-rate communication system where the transmission is suspended if the received SNR falls below a given threshold. We assume an FDD system and derive novel closed-form bit error probabilities in the presence of feedback errors in flat Rayleigh fading environment for single antenna transmission, orthogonal space-time block coding and ...
Hämäläinen Jyri, Wichman Risto
openaire +1 more source
On the minimum bit-error rate of linear codes
IEEE Transactions on Information Theory, 1995Summary: We investigate the bit-error rate (BER) of linear block codes. The BER is a function of the encoder realization of the code. We express the BER in terms of the weight profiles of the subspaces of the code. We also discuss the relation between the Hadamard transform and the BER.
openaire +1 more source
Determining the Bit Error Rate for Redundant Transmission
2016In this article a bit error rate for redundant transmission is determined. The method is based on the error rate of received bitstream for different levels of redundancy and does not require any information about transmission channel and original data. The main goal was to derive a simple closed form expression that leads to good performance and makes ...
Przemyslaw Wlodarski, Piotr Lech
openaire +2 more sources
The Information-Bit Error Rate for Block Codes
IEEE Transactions on Communications, 1984The relations between the word error probability and the decoding algorithms for block codes are reviewed. A simple approximation that does not depend upon the code weight structure or the decoding details is derived for the information-bit error rate in terms of the channel-symbol error probability.
openaire +1 more source

