Results 11 to 20 of about 27,123 (264)
Case Studies in Thermal Engineering, 2021 Modifying the surface wettability at the solid-liquid interface can significantly improve flow boiling heat transfer. The graphene nanoplatelets (GNPs) and epoxy additives form nanocomposites coatings with tunable wettability (superhydrophilic ...
Geng Di Sia +3 more
doaj +1 more source
Experimental investigation on partial pool boiling heat transfer in pure liquids [PDF]
Chemical Industry and Chemical Engineering Quarterly, 2016 Saturated partial pool boiling heat transfer has been experimentally investigated on a horizontal rod heater. The boiling liquids are including water and ethanol. The heating section is made by various materials including SS316, copper, aluminum
Fazel Seyed Ali Alavi +1 more
doaj +1 more source
Study on Flow Boiling Heat Transfer in Segmented Internally-Threaded Tube [PDF]
Journal of Applied Fluid Mechanics, 2022 The flow boiling heat transfer characteristics of R245fa in segmented internally-threaded tubes are studied experimentally. The heat transfer performances of smooth tube, front-threaded tube, rear-threaded tube, and full-threaded tube are compared.
J. Yang +5 more
doaj +1 more source
Experimental Investigation of Sub-Cooled Flow Boiling in Metallic Microchannel [PDF]
Engineering and Technology Journal, 2019 Experiments in microchannel heat sink were carried that examine the deionized water two-phase boiling heat transfer. The heat sink consisted of a single microchannel having 300μm wide nominal dimensions and 300μm height (hydraulic diameter of 300μm). The
Suha mohammed, Ekhlas Fayyadh
doaj +1 more source
Energies, 2023 Heat dissipation in high-heat flux micro-devices has become a pressing issue. One of the most effective methods for removing the high heat load of micro-devices is boiling heat transfer in microchannels. A novel approach to flow pattern and heat transfer
Bin Yang +6 more
doaj +1 more source
AIP Advances, 2021 The heat transfer rate during nucleate flow boiling conditions inside a horizontal heated pipe is assumed to increase with the heat flux until the boiling crisis while being independent of the mass flux.
Subhanker Paul +3 more
doaj +1 more source
A study on transition process to MEB by limiting boiling space
Journal of Thermal Science and Technology, 2021 The study of microbubble emission boiling (MEB) is gaining popularity because it violently emits several microbubbles during subcooled pool boiling, for which the heat flux is greater than the critical heat flux (CHF).
Kendai KAWAKAMI +3 more
doaj +1 more source
Pool boiling heat transfer performance of the surface modified with laser [PDF]
MATEC Web of Conferences, 2022 The paper deals the problem of pool boiling heat transfer on the surface produced by the modification with the laser beam. The laser enabled to produce grooves and roughness which have a positive impact on heat transfer.
Orman Łukasz J. +3 more
doaj +1 more source
Case Studies in Thermal Engineering, 2021 This study tries to employ the computational fluid dynamics (CFD) approach to investigate the influence of the simultaneous use of the metal foam (porous media) and the water-based nanofluid on the boiling flow regime. For this purpose, boiling flow heat
S. Sivasankaran, Fouad O.M. Mallawi
doaj +1 more source
Advances in Mechanical Engineering, 2016 In order to investigate the characteristics of boiling heat transfer for hydrocarbon mixture refrigerant in plate-fin heat exchanger which is used in the petrochemical industry field, a model was established on boiling heat transfer in vertical ...
Huixing Li, Yu Liu
doaj +1 more source