Results 181 to 190 of about 1,100,486 (356)

Screen‐Printed Flexible Piezoelectric Force Sensor Array with Electromagnetic Interference Shielding

Advanced Engineering Materials, EarlyView.
This article introduces a flexible screen‐printed piezoelectric sensor array designed for low‐frequency healthcare applications such as tactile sensing and cardiovascular monitoring. The device integrates interface electronics enabling the simultaneous acquisition of up to 128 signals, along with flexible EMI shielding that significantly reduces noise ...
Joseph Faudou, Mohammed Benwadih, Arnaud Gabas, Lina Kadura, Minh‐Quyen Le, Daniel Grinberg, Pierre‐Jean Cottinet   +6 more
wiley   +1 more source

Effect of Gutta-Percha Removal Methods on Fiber-Post Bond Strength. [PDF]

Dent J (Basel)
Hamwieh AR, Elbishari H, Aljanahi M, Amir-Rad F, Atmeh AR, Abuzayeda M, Khamis AH, El Abed R.   +7 more
europepmc   +1 more source

Predicting Bond Strength in Single Particles Impacted by Cold Spray: A Shock Wave Approach

Luis Alonso, M.A. Garrido, P. Poza, Mostafa Hassani   +3 more
openalex   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Effect of saliva contamination and decontamination procedures on bond strength to framework materials. [PDF]

BMC Oral Health
Yeşil Z, Çağlar İ, Er A, Kalafat ÇN, Yeşil Ç.   +4 more
europepmc   +1 more source

Effect of Confinement Using Gfrp Stirrups on Bond Strength of Staggered/Non-Staggered Lap-Spliced Gfrp Bars in Concrete Beams

Seyed Arman Hosseini, Abolfazl Eslami, Ahmed Sabry Farghaly, Brahim Benmokrane   +3 more
openalex   +1 more source

Shear and micro-shear bond strengths of four self-etching adhesives measured immediately and 24 hours after application

, 2012
Choltacha Harnirattisai, Panitta ROENGRUNGREANG, Utumporn RANGSISIRIPAIBOON, Pisol Senawongse   +3 more
openalex   +2 more sources

Influence of different acid etching times on the shear bond strength of brackets bonded to bovine enamel

, 2020
Clyvis Maurício Ferreira da Silva, André Felipe de Menezes Costa, Ana Rosa Costa, José Guilherme Neves, Ana Paula Terrosi de Godói, Vívian Fernandes Furletti de Goés   +5 more
openalex   +1 more source

Removing Homocoupling Defects in Alkoxy/Alkyl‐PBTTT Enhances Polymer:Fullerene Co‐Crystal Formation and Stability

Advanced Functional Materials, EarlyView.
PBTTT‐OR‐R, a C14‐alkoxy/alkyl‐PBTTT polymer derivative, is of substantial interest for optoelectronics due to its specific fullerene intercalation behavior and enhanced charge‐transfer absorption. Comparing this polymer with (S) and without (O) homocoupling defects reveals that PBTTT‐OR‐R(O) forms stable co‐crystals with PC61BM, while PBTTT‐OR‐R(S ...
Zhen Liu, Jochen Vanderspikken, Paola Mantegazza, Stefania Moro, Mouna Hamid, Sigurd Mertens, Niko Van den Brande, Laurence Lutsen, Vincent Lemaur, David Beljonne, Giovanni Costantini, Koen Vandewal, Bruno Van Mele, Wouter Maes, Bart Goderis   +14 more
wiley   +1 more source

Impact of dynamic bond strength on the training of liquid crystal elastomers. [PDF]

Chem Sci
Ghimire E, Appen IS, Lindberg CA, Blagitz de Abreu E Silva L, Rowan SJ.   +4 more
europepmc   +1 more source