Results 181 to 190 of about 1,314,183 (287)
Synergistic Effect of a Combined 10-MDP/γ-MPTS Primer on Glass-Ceramic Bonding: A Multimodal Study. [PDF]
Liu J, Xu Y, Lin Z, Tu S, Chen C, Xie H.
europepmc +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Enhancing Effect of Coupling Agent Sizing on the Mechanical Properties of Carbon Fiber Reinforced Acrylonitrile-Butadiene-Styrene Composites. [PDF]
Yao Y +6 more
europepmc +1 more source
The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Enhanced Stability of Halide Perovskite by Strengthening Hydrogen Bonds. [PDF]
Yin Y +9 more
europepmc +1 more source
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Investigating the effects of Fe, Ni, or Cu additions on the microstructure and mechanical properties of W₂CoB₂ cermets. [PDF]
Zhu X, Pan Y, Ke D, Qu F, Liu L.
europepmc +1 more source
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Non-covalent assembly-enabled selectivity in aqueous microdroplets. [PDF]
Ma Z +5 more
europepmc +1 more source

