Results 31 to 40 of about 259 (168)
A novel asymmetrical interleaved dc/dc switching converters family intended for photovoltaic and fuel cell applications is presented in this paper. The main requirements on such applications are small ripples in the generator and load, as well as high ...
Sergio Serna +4 more
doaj +1 more source
This article presents the modeling of a flyback converter integrated in a two-stage photovoltaic microinverter with grid connection, and the design of the respective controllers.
César Leonardo Trujillo Rodriíguez +2 more
doaj +1 more source
Transformer design considerations for noncontinuous mode, boost, flyback converters [PDF]
This paper presents some design considerations for small, flyback transformers used to charge energy storage capacitors from 0.1 to 5 kV from a low voltage DC source. The transformer has two roles: to act as an energy storage device, and to ratio the primary to secondary voltages.
openaire +1 more source
This paper proposes a high step-up high-efficiency converter, comprised of an active switched coupled-inductor cell. The secondary windings are integrated into a rectifier voltage multiplier cell in a boost-flyback configuration, allowing the operation ...
Eduardo Augusto Oliveira Barbosa +5 more
doaj +1 more source
A Module‐Level Photovoltaic Optimizer for Online I–V Curve Tracing and Daylight Photoluminescence
This article presents a module‐level photovoltaic optimizer based on a synchronous buck converter. The system enables non‐invasive online I–V curve tracing and daylight photoluminescence imaging. By integrating advanced diagnostic capabilities with minimal hardware modifications, this compact solution offers cost‐effective, continuous inspection ...
Alberto Redondo‐Plaza +5 more
wiley +1 more source
Echo‐Planar‐Based Time‐of‐Flight Imaging Using a Modified Interleaved Flyback Trajectory
ABSTRACT Purpose A modified interleaved flyback (miFB) approach is introduced, designed to mitigate flow artifacts caused by alternating readout polarities in Echo Planar Imaging (EPI), while preserving acquisition efficiency. Methods We propose reconstructing odd and even echoes of 3D‐EPI separately.
Simon Blömer +2 more
wiley +1 more source
This work presents the analysis of a high power factor power supply operating at high switching frequency. An almost unity input power factor is obtained when an interleaved Boost-Flyback converter associated with a nondissipative snubber is used as a ...
Carlos A. Gallo +6 more
doaj +1 more source
As estruturas de um indutor acoplado com dois e três enrolamentos têm ganhado popularidade nas aplicações de conversores de alto ganho de tensão. Essas células permitem gerar uma infinidade de topologias de conversores.
Pablo Henrique Costa da Silva Bernardo Loureiro +1 more
doaj +1 more source
Highly Reproducible, Vendor‐Agnostic, Motion‐Insensitive Liver PDFF Mapping at 0.55T, 1.5T, and 3T
ABSTRACT Purpose To develop and validate a vendor‐agnostic, motion‐insensitive proton‐density fat‐fraction (PDFF) quantification method. Methods Flip‐angle‐modulated (FAM) 2D chemical‐shift‐encoded (CSE) MRI for PDFF quantification was implemented in both the vendor‐agnostic platform Pulseq (“Pulseq‐FAM”) and one vendor‐specific platform (“GE‐specific ...
Jiayi Tang +27 more
wiley +1 more source
ABSTRACT Purpose To develop a fat‐water separation approach that corrects bipolar readout gradient‐induced effects without additional scans and is compatible with any fat‐water separation method. Theory and Methods The proposed approach combines joint fat‐water separation of the odd and even echoes of a bipolar multi‐echo gradient echo acquisition with
Jorge Campos Pazmiño +3 more
wiley +1 more source

