Results 11 to 20 of about 1,422,187 (304)
Non-isolated Modified Quadratic Boost Converter with Midpoint Output for Solar Photovoltaic Applications [PDF]
E3S Web of Conferences, 2019 This paper presents a boost DC-DC converter topology with non - isolated high gain and output midpoint, to boost the voltage obtained from solar photovoltaic panels.
Ravivarman Shanmugasundaram +2 more
doaj +1 more source
The Boost Converter – Revisited [PDF]
Renewable Energy and Sustainable Development, 2015 The dc-to-dc boost converter is a single-switch, single-inductor, switching circuit used to efficiently transform energy from one dc voltage level to a greater voltage level of the same relative polarity. For a specific resistive load range, as the duty cycle decreases, the boost converter inductor enters a discontinuous current mode of operation - the
Williams, B. W., Lim, T. C.
openaire +4 more sources
New High-Gain Transformerless DC/DC Boost Converter System
Electronics, 2022 This article proposes a new high-gain transformerless dc/dc boost converter. Although they possess the ability to boost voltage at higher voltage levels, converter switching devices are under low voltage stress.
H. Ahmed, Omar Abdel-Rahim, Ziad M. Ali
semanticscholar +1 more source
The Design of 2S2L-Based Buck-Boost Converter with a Wide Conversion Range
International Transactions on Electrical Energy Systems, 2023 This manuscript proposes a novel nonisolated negative output buck-boost converter topology for wide voltage conversion applications. To design this converter, a typical buck-boost converter configuration is used. In conventional buck-boost converter, the
B. Nagi Reddy +5 more
doaj +1 more source
Jurnal EECCIS (Electrics, Electronics, Communications, Controls, Informatics, Systems), 2021 Penelitian ini membahas tentang topologi baru dari dc-dc konverter jenis boost, yakni quadratic boost converter berbasis low buffer capacitor stress yang dibandingkan dan dianalisis prinsip kerjanya dengan boost converter.
Hery Purnomo +2 more
doaj +1 more source
Impact of converter interface type on the protection requirements for DC aircraft power systems [PDF]
, 2012 The utilization of converter interfaces has the potential to significantly alter the protection system design requirements in future aircraft platforms.
Burt, Graeme +3 more
core +4 more sources
International Journal of Photoenergy, 2021 In this paper, a high step-up DC-DC interleaved boost converter is proposed for renewable sources with low voltages such as photovoltaic module and fuel cell.
Muhammad Yaseen +5 more
doaj +1 more source
Design and Simulation Converter with Buck-boost Converter as The Voltage Stabilizer
International Journal of Electrical, Energy and Power System Engineering, 2020 Buck-boost Converter is the device with the function to convert DC Voltage input to the setpoint DC Voltage output. Buck-boost converter can be used for regulating unstable voltage became a stable voltage by the user’s needs. Using a Buck-boost Converter
Aris Suryadi +2 more
doaj +1 more source
Fault-tolerant control for a modular generator and converter scheme for direct-drive wind turbines : Industrial Electronics, IEEE Transactions on [PDF]
, 2011 A modular power electronic converter, with a cascaded H-bridge multilevel inverter, has been proposed as the grid interface for a large direct drive wind turbine generator.
Parker, Max +3 more
core +4 more sources
Reset control of boost converters [PDF]
2018 Annual American Control Conference (ACC), 2018 The goal of this work is to apply the framework of reset systems, in particular PI+CI controllers, in the controller design for power converters. While the PI+CI controller has been applied in several industrial applications, the application of such controllers in fast electrical systems especially power electronic converters appears to be new.
Raveendran Nair, Unnikrishnan +2 more
openaire +2 more sources