Results 311 to 320 of about 83,885 (352)
Some of the next articles are maybe not open access.
Isolated voltage-boosting converter
2014 International Power Electronics Conference (IPEC-Hiroshima 2014 - ECCE ASIA), 2014In this paper, a single switch isolated voltage-boosting converter is presented, which is derived from the traditional flyback converter and charge pump concept. The proposed converter possesses an output inductor, so the output current is non-pulsating.
K. I. Hwu, W. Z. Jiang, Jenn-Jong Shieh
openaire +1 more source
2011 IEEE Ninth International Conference on Power Electronics and Drive Systems, 2011
In this paper, a dual-output boost converter with positive and negative output voltages under a single positive voltage source fed. Due to its dual output with positive and negative output voltages, this converter is very suitable for driving the half-bridge class-D amplifier, so as to remove a DC blocking capacitor required in the half-bridge class-D ...
K. I. Hwu +2 more
openaire +1 more source
In this paper, a dual-output boost converter with positive and negative output voltages under a single positive voltage source fed. Due to its dual output with positive and negative output voltages, this converter is very suitable for driving the half-bridge class-D amplifier, so as to remove a DC blocking capacitor required in the half-bridge class-D ...
K. I. Hwu +2 more
openaire +1 more source
A Novel Voltage-boosting Converter: KY Converter
APEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition, 2007In this paper, a novel voltage-boosting converter, named as KY converter (i.e. one-plus-D converter) is presented herein. Unlike the traditional non-isolated boost converter, this converter possesses fast transient load responses, similar to the buck converter behavior. Besides, it possesses non-pulsating output current, thereby not only decreasing the
K. I. Hwu, Y. T. Yau
openaire +1 more source
Predictive control of parallel boost converters
2008 34th Annual Conference of IEEE Industrial Electronics, 2008In this paper a novel predictive control for parallel power factor correction (PFC) scheme is proposed. It is based on an optimized power sharing where the active filtering approach is used in order to increase the current quality and, at the same time, to reduce the switching losses.
C. ATTAIANESE +3 more
openaire +3 more sources
Research of an interleaved boost converter with four interleaved boost convert cells
2009 Asia Pacific Conference on Postgraduate Research in Microelectronics & Electronics (PrimeAsia), 2009Boost converters are widely used in the low-to-high DC/DC application and power-factor-corrected circuits. Based on the interleaved boost converter with coupled inductors, a converter consisting of four interleaved boost converter cells is proposed in this paper.
Chunliu Chen, Chenghua Wang, Feng Hong
openaire +1 more source
Fault-Tree Based Failure-Rate Analysis for Boost Converter and Interleaved Boost Converter
Journal of Electrical Engineering & Technology, 2019The conventional part failure analysis only takes into account the type, number, and connection status of the components, so failure rates according to the operating characteristics of the converter cannot be reflected. On the other hand, FTA uses a fault-tree showing cause, effect, and result of the fault, so it can predict the failure-rate ...
Sung Chan Yeo, Feel-soon Kang
openaire +1 more source
Boost Converter — Battery Discharger
2003In Fig. 6-1, a simple, non-isolated DC-DC boost converter is shown. The converter employs peak current, current-mode control in regulating the main switch’s on/off duty cycle, which in turn regulates the output voltage V0.
openaire +1 more source
Comparison of Boost-Type ĆUK'S PWM-Resonant Converter with Conventional Boost Converter
2018 2nd International Symposium on Multidisciplinary Studies and Innovative Technologies (ISMSIT), 2018In this study, boost-type Cuk's PWM-resonant converter is compared with the conventional boost converter in terms of required inductor size, efficiency, and dynamic response. The inductor sizes required by both topologies are selected based upon the core geometrical constant design method.
openaire +1 more source
2023 5th International Conference on Power and Energy Technology (ICPET), 2023
Ikram El Haji +3 more
openaire +1 more source
Ikram El Haji +3 more
openaire +1 more source
Photothermal Nanomaterials: A Powerful Light-to-Heat Converter
Chemical Reviews, 2023Ximin Cui, Qifeng Ruan, Xiaolu Zhuo
exaly