Results 41 to 50 of about 394,780 (333)
Study on Vertical Load-Carrying Capacity of Post-Grouting Bored Piles
The relationship between pile side frictional resistance and pile tip resistance and settlement is assumed to be ideal elastic–plastic. The load-transfer method is used to analyze the load-bearing characteristics of bored pile in actual projects, and the
Dezhi Kong, Heng Li, Wensong Gan
semanticscholar +1 more source
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
Accelerated in situ formation of TiB and TiC in Ti–5Al–2.5Sn–B4C is driven by transient liquid phase formation, which enhances particle reactions and microstructural evolution. This process increases hardness and establishes a coupled relationship between sintering temperature and reinforcement content, strongly influencing porosity in the resulting ...
Fernando. Y. Kojima, Juliano. Soyama
wiley +1 more source
The construction site of a silo, which was built as two sites, consists of very soft alluvial soils. Since the superstructure loads exceeded the bearing capacity of the shallow foundation, the structure was built on a deep foundation with bored piles ...
Karaaslaner Ufuk +4 more
doaj +1 more source
Edible Cuttlefish Ink: Complex Chemistry, Structure, and Electrical Response
An integrated approach of chemistry‐structure‐electrical properties is used to assess the potential of edible cuttlefish ink as a bio‐based conductive ink for printable electronics. Chromatography and Neutron Activation Analysis reveal a fascinating molecular and elemental diversity.
Camille Bour‐Cardinal +5 more
wiley +1 more source
In order to solve the problem that the current geophysical method is difficult to locate in the mud of bored piles, the problem of effective exploration of karst caves at the bottom of piles, the author puts forward the application of Internet of Things ...
Jiayin Liu +4 more
doaj +1 more source
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source
Electrospun Wood‐Derived Biopolymers as Electrodes in Electrochemical Energy Storage Technologies
Electrospinning transforms wood‐derived cellulose and lignin into architecturally defined, binder‐free carbon electrodes with tuneable porosity and functionality. This review shows how fibre design enables decoupled charge and mass transport, enhancing performance across battery systems, while identifying key challenges in spinnability, scalability ...
Michael W. Thielke +3 more
wiley +1 more source
ASSESSING THE INCREASE IN BEARING CAPACITY OF BORED PILES IN SANDY SOIL USING EXPANSIVE ADDITIVES
The pile foundation is usually designed to exceed the weak soil to the strong stratum. There is very close relation between the pile capacity and surrounding soil conditions.
Makki K. Al-Recaby
doaj +1 more source
Some experiences with bored and auger piles in Naples area
Experimental evidence on load-settlement behaviour of foundation piles in the volcanic soils of Naples area is presented and discussed. The variability of behaviour among piles of the same foundation seems independent of the pile technology (bored ...
CAPUTO, Vincenzo, C. Viggiani
core +1 more source

