Results 21 to 30 of about 683 (147)
Submarine cables are critical components for power transmission in offshore wind farms, making their condition monitoring paramount for ensuring operational reliability.
Manting Guo +5 more
doaj +2 more sources
Dynamic range optimization for treatment time reduction in respiratory-gated proton therapy using RayStation v2025. [PDF]
Abstract Purpose This study introduces dynamic range optimization, which constrains the lower limit of the minimum MU per spot, as a planning‐based strategy to enhance efficiency in respiratory‐gated proton therapy and evaluates the resultant dosimetric trade‐offs.
Cho S, Yu JI, Park HC, Jo K.
europepmc +2 more sources
提出了一种利用非线性反射镜提高布里渊光时域反射仪(BOTDR)系统信噪比的新型传感结构。通过将两根相同类型的传感光纤敷设在同一待测温度或应变环境下,结合光纤3 dB耦合器,可以形成非线性反射镜。利用非线性反射镜可以将传感系统输出信号的强度提高到只用一根传感光纤时的4倍,既能改善系统的信噪比及测量精度,也能提高传感系统的可靠性。
李勇涛 +4 more
doaj +2 more sources
Denoising of Brillouin Gain Spectrum Images for Improved Dynamic Measurements of BOTDR
Brillouin optical time-domain reflectometry (BOTDR) is widely used for strain and temperature measurements in various fields. However, the accuracy and reliability of the measurements are often limited by the noise in the sensor signals.
Bo Li, Ningjun Jiang, Xiaole Han
doaj +1 more source
Abstract Ground temperature measurements are crucial for a better understanding of changes in the natural environment, especially in the Arctic. Previous measurement systems provided accurate measurements; however, their most significant disadvantage was the relatively low spatial resolution, including in the vertical profile.
Piotr Zagórski +12 more
wiley +1 more source
Investigation of the Radiation Effect on BOTDR Under Low Space Radiation Doses
To verify the feasibility of Brillouin optical time domain reflector (BOTDR) applied in space station, three kinds of commercial fibers, YOFC fiber (about 1 km), Corning fiber (about 1 km) and Fujikura fibers (about 1.5 km), have been radiated by Co60 in
Mi Li +5 more
doaj +1 more source
A simplified Brillouin observation setup is developed by removing an independent reference path and incorporating a variable reflectivity mirror at the fibre end. This setup inherently mitigates the polarisation‐dependent fluctuations of the Brillouin gain spectrum.
Haruki Sasage +3 more
wiley +1 more source
Abstract The quality of strain measurements using distributed fiber optic sensors (DFOS) depends largely on the bond between the host material and the optical fiber. Experimental investigations were carried out to test the suitability of five different DFOS types for crack monitoring.
Max Herbers +4 more
wiley +1 more source
Short-time Fourier transform is utilized for the data processing of traditional point-frequency Brillouin optical time-domain reflectometry (BOTDR). This method can improve the measurement speed, but theoretically there is a contradiction between spatial
Xuan Li +4 more
doaj +1 more source
Influence of reference path length on self‐heterodyne‐based Brillouin observation
The authors investigate the impact of delay fibre length on Brillouin gain spectra. Increasing delay fibre length reduces the power of the lower‐frequency peak from a sensing fibre and increases the power of the higher‐frequency peak from the delay fibre. This result indicates the existence of an optimal delay fibre length.
Mana Sakamoto +4 more
wiley +1 more source

