Results 21 to 30 of about 374,438 (321)
Electrical Discharge Machining of Alumina Using Ni-Cr Coating and SnO Powder-Mixed Dielectric Medium
Metals, 2022 Aluminum-based ceramics exhibit excellent wear resistance and hot hardness that are suitable for various responsible applications allowing products to work under extreme mechanical and thermal loads (up to 1000 °C).
Anna A. Okunkova +4 more
doaj +1 more source
Corrosion and Materials Degradation, 2021 The local patterns at the interfaces of corrosion stratification, developed on two archaeometallurgical bronzes (a Cu-Sn-Pb and a Cu-Zn-Sn-Pb alloy), in the as-cast condition, were assessed by OM and SEM-EDS systematic elemental chemical analyses ...
Olga Papadopoulou, Panayota Vassiliou
doaj +1 more source
Effect of Thickness Reduction on Cold Rolling Process to Microstructure and Brass Hardness
MATEC Web of Conferences, 2018 Brass is an alloy between copper (Cu) and zinc (Zn) where the majority of the elements are copper. Brass that undergoes a cold rolling process will experience changes in microstructure and mechanical properties.
Darmawan Agung Setyo +4 more
doaj +1 more source
Effect of cold rolling and annealing temperature to the characteristics of α + β' phases in Cu-29.5Zn-2.5Al alloy produced by gravity casting [PDF]
Journal of Mining and Metallurgy. Section B: Metallurgy, 2020 Al-brass alloys (Cu29.5Zn2.5Al wt. %) were produced by gravity casting and homogenized at 800°C for 2 h, resulting in a binary phase morphology identified as cubic α and martensitic βʹ phases through X-ray diffraction (XRD).
Angela I., Basori I., Sofyan B.T.
doaj +1 more source
Metals, 2017 The electropolishing behaviour of 73 brass was studied by means of a rotating cylinder electrode (RCE) in a 70 vol % H3PO4 solution at 27 °C. Owing to the formation of a blue Cu2+-rich layer on the brass-RCE, an obvious transition peak was detected from ...
Ching An Huang +2 more
doaj +1 more source
Tehnički Vjesnik, 2022 In this study, measurement of the effect of singular, bimetallic and multimetallic materials exposed to cold plastic deformation on electrical conductivity properties was investigated. The main subject of this research is plastic deformation occurring in
Isik Cetintav, Cenk Misirli, Yilmaz Can
doaj +1 more source
Analysis of the Possibility of Calculating the Charges on the Example of Brasses
Archives of Metallurgy and Materials, 2017 This paper describes the subject of brasses and the method of their production from the secondary raw materials. It focuses on two very important aspects extremely important for today’s world.
Biernat S. +3 more
doaj +1 more source
Modern brass band: its components and activities
Науковий Вісник Південноукраїнського Національного Педагогічного Університету імені К. Д. Ушинського, 2022 The article covers the modern composition of a brass band, the main musical instruments that make up performing groups; the features of sound, range, tessitura of traditional musical instruments.
Stepanova Anna
doaj +1 more source
, 2018 We studied the microstructural evolution of the low stacking fault energy $\alpha$-brass alloy CuZn15 during accumulative roll bonding (ARB). Most notably, the typical brass-type texture was clearly observed after four ARB passes (approx.
Böhme, Marcus, Wagner, Martin F. -X.
core +1 more source