Results 111 to 120 of about 402,320 (302)

LFA: A Lattice Fourier Analyzer for Quantitative In Situ EC‐STM of Adsorbate–Substrate Superstructures

Advanced Materials Interfaces, EarlyView.
Although electrochemical scanning tunneling microscopy provides atomic‐scale access to electrified interfaces, quantitative in situ and operando investigations suffer from drift‐induced distortions. This work introduces the Lattice Fourier Analyzer (LFA), which employs substrate‐anchored affine drift correction in reciprocal space to recover precise ...
Rafał Lewandków, Paulina Wira, Anna Futyma, Radosław Wasielewski, Tomasz Kosmala   +4 more
wiley   +1 more source

Structural Review of a Bridge for Condition Assessment

ABUAD Journal of Engineering Research and Development
The cost of performing a thorough bridge condition assessment is prohibitive, as it requires the installation of sensors, weigh-in-motion bridge facilities, load tests, destructive and non-destructive testing, and monitoring of the data they provide to ...
Ebiserigha Nemine, Ogheneale Orie
doaj   +1 more source

Structural health monitoring and bridge condition assessment [PDF]

, 2016
Thesis (Ph.D.) University of Alaska Fairbanks, 2016This research is mainly in the field of structural identification and model calibration, optimal sensor placement, and structural health monitoring application for large-scale structures.
Xiao, Feng, 肖枫
core  

Topological Point Defects in SmC* Liquid Crystals Under Mechanical Disturbance

Advanced Materials Interfaces, EarlyView.
Tangetial air jet shear inducess island formation and nucleates topological point defects in uniform SmC films. Island bounded by edge dislocation loops shrink and transform into isolated point defects under continued shear. Mechanical perturbatio provides a controllable route for defect engineering in smectric liquid crystal thin films.
Gunganist Kongklad, Vandana Molahalli, Apichart Pattanaporkratana, Nattaporn Chattham   +3 more
wiley   +1 more source

BIM-Based Trajectory Planning for Unmanned Aerial Vehicle-Enabled Box Girder Bridge Inspection

Remote Sensing
Inspection is essential for bridge maintenance and has been supplemented by the use of unmanned aerial vehicle (UAV) photogrammetry. However, a review of the literature reveals that existing approaches require the intervention of a human operator to ...
Jiangpeng Shu, Zhe Xia, Yifan Gao
doaj   +1 more source

Simple non-destructive tests for electroexplosive devices [PDF]

, 1972
Electrothermal behavior of bridgewire-explosive interface is defined by pulsing electroexplosive device with a safe level of current and examining the resistance variation of bridgewire. Bridgewire provides signal which describes average wire temperature
Menichelli, V. J., Rosenthal, L. A.
core   +1 more source

Microfluidic Engineering of Chitosan‐Coated Nanoemulsions for Controlled Release and Stability in Space Pharmaceutics

Advanced Materials Technologies, EarlyView.
Microfluidic engineering enables the fabrication of chitosan‐coated, melatonin‐loaded nanoemulsions with controlled release and enhanced physicochemical stability for space pharmaceutics. Interfacial biopolymer coating modulates droplet behavior under accelerated thermal stress and simulated microgravity.
Modupe Adebowale, Nguyen Van Duc Long, Philip M Williams, Volker Hessel   +3 more
wiley   +1 more source

Laboratory and Field Testing of an Accelerated Bridge Construction Demonstration Bridge: US Highway 6 Bridge over Keg Creek, RB02-012, 2013 [PDF]

, 2013
The US Highway 6 Bridge over Keg Creek outside of Council Bluffs, Iowa is a demonstration bridge site chosen to put into practice newly-developed Accelerated Bridge Construction (ABC) concepts.

core  

Cap‐oPMN: Oral Inflammatory Load Quantification Using Capillary Microfluidics and Automated Image Processing

Advanced Materials Technologies, EarlyView.
ABSTRACT Quantifying oral polymorphonuclear neutrophils (oPMNs) is a clinically validated approach for assessing periodontal inflammation. However, current methods, such as manual hemocytometry and flow cytometry, are time‐consuming (>3 h), require invasive sampling, and depend on staining and complex instrumentation, making them unsuitable for point ...
Mohsen Hassani, Azam Zare, Fatemeh Soheili, S. M. Mahdi H. Daneshvar, Mahdi Amrollahi Biouki, Yasaman Tahernezhad, Chunxiang Sun, Michael Glogauer, Ebrahim Ghafar‐Zadeh, Amir Sanati‐Nezhad   +9 more
wiley   +1 more source

Hierarchical Multi‐Material Architectures With Gradient Design for Dynamic‐Range Flexible Tactile Sensing

Advanced Materials Technologies, EarlyView.
Hierarchical multi‐material TPMS lattices are engineered as flexible tactile sensors by combining soft and stiff elastomeric layers with a conformal conductive coating. The bilayer architecture delivers sensitivity at low pressures while maintaining a broad detectable range under large loads, enabling reliable pressure and vibration monitoring for ...
Reza Noroozi, Domenic Quiquero, Yan Yan Shery Huang, HaoTian Harvey Shi   +3 more
wiley   +1 more source