Results 71 to 80 of about 9,560 (208)
Low Temperature Impact Toughness of Steel S355NL for Wind Power Tower Flange
Teshugang, 2015 The tangential and axial impact toughness of steel S355NL for wind power tower flange (/% : 0.14C, 0.22Si, 1.35Mn, 0.010P, 0.002S, 0.06Cr, 0.01Mo, 0.l0Ni, 0.03Cu, 0.40Ceq) at -20~-80℃ has been tested and analyzed.
戈文英
doaj
Experimental investigation on material removal and brittle–ductile transition of SiC ceramics milling regarding milling force characteristic and tool wear [PDF]
, 2021 Jian Qiu, Renpeng Ge, Han Tingchao
openalex +1 more source
Frontiers in Earth ScienceEarthquake occurrence depth in the crust is related to stress, temperature, and brittle–ductile transition, which is also near the transition depth of the upper to lower crust. The composition variation between the upper and lower crust causes remarkable
Junshan Xu, Xiangfang Zeng
doaj +1 more source
eXPRESS Polymer Letters, 2007 The percolation model was applied in the study of brittle to ductile transition (BDT) of polystyrene (PS) and polyolefin elastomer (POE) blends. Based on the interparticle distance and percolation model, stress volume (Vs) can be expressed by volume ...
doaj +1 more source
Ductile to Brittle Transition Behavior in Cast Duplex Stainless Steels
, 2014 Osamu Takahashi +3 more
openalex +1 more source
Investigation of ductile-brittle transition in machining of yttrium-stabilized zirconia (YSZ)
, 2018 Hae-Sung Yoon, Seola Lee, Sangkee Min
openalex +1 more source
Brittle to ductile transition during indentation of ice
Canadian Journal of Civil Engineering, 1991 The brittle to ductile transition in the deformation behaviour of ice is considered for indentation by a flat, rigid indentor under fully elastic plane strain or plane stress conditions. It is assumed that failure occurs when a crack initiated near an edge of the indentor is propagated immediately by the maximum shear stress at the site. Consideration
openaire +3 more sources
Optimal Design of Mises Truss with Respect to Time to Creep Rapture
Engineering Transactions, 1994 The paper deals with problem of optimal choice of slope angle for bars of Mises truss in creep conditions. Results of optimization with respect to brittle creep rupture coincide with elastic solution (45°), while for ductile creep rupture there is no ...
K. Szuwalski
doaj
The influence of precipitates on the brittle-ductile transition of chromium
, 1967 Robert Clark Tucker
openalex +2 more sources