Results 121 to 130 of about 367,950 (254)
Incorporating AI to optimize solution, process, and environment enables efficient prediction of structural properties and performance, allowing tailoring of GDL, CL, and PEM fabrication to guide PEMFC toward 9.0 kW L‒1 by 2040. ABSTRACT The performance and commercial viability of proton exchange membrane fuel cells (PEMFCs) are constrained by key ...
Shangfeng Jiang +11 more
wiley +1 more source
Cryogenic helium subsurface pressurization in terrestrial and low-gravity: experiments and flow visualization. [PDF]
Yu J +5 more
europepmc +1 more source
Numerical Simulation and Experimental Study for the Impact of In-Flow Nozzle on Spray Characteristics. [PDF]
Mohamed MAE +4 more
europepmc +1 more source
A dual‐functional evaporator based on CAU‐23/graphene hybrid is acquired through a modular design strategy. Owing to superior broadband light absorption, optimal wettability, and porous architecture that synergistically integrates nanoconfined ionic channels with photothermal conversion, it exhibits a high evaporation rate of 2.71 kg m−2 h−1 with the ...
Hangyuan Du +8 more
wiley +1 more source
Flow regime transitions in flow blurring injection through a CFD parametric study. [PDF]
S Madani SA +3 more
europepmc +1 more source
Analytical Investigation of the Impact of Jet Geometry on Aeration Effectiveness Using Soft Computing Techniques. [PDF]
Puri D +6 more
europepmc +1 more source
The steel industry accounts for about 7%‐9% of global CO2 emissions. While H2‐based direct reduction is a long‐term route, near‐term solutions are needed for existing plants. Internal carbon cycles reuse steelworks off‐gases and by‐products, enabling circular carbon use and supporting CCU integration.
Florian Haakmann +4 more
wiley +1 more source
Numerical Investigation of Downstream-Shaft Aeration and Air-Pocket Evolution in a Navigation-Lock Valve. [PDF]
Xie T, Li Z, Yan X, Deng J, Xu D.
europepmc +1 more source
Integral Experiments and Magnetic Resonance Imaging of Lab‐Scale Liquid Distributors
Four lab‐scale liquid distributors were evaluated based on the homogeneity of the resulting liquid distribution. The best‐performing design reduced maldistribution and wall flow compared to a single‐point liquid distribution and remained stable under varying operating conditions, including different gas and liquid loads.
Hannah S. Rennebaum +4 more
wiley +1 more source
A novel approach to develop the turning tool for cryogenic internal cooling. [PDF]
Gan Y +5 more
europepmc +1 more source

