Incorporation and solidification mechanism of manganese doped cement clinker
Frontiers in Chemistry, 2023 Using municipal and industrial solid waste as a substitute raw material and fuel in cement rotary kiln co-processing is considered an economic and environmentally friendly alternative to the use of traditional fuels. However, the presence of heavy metals
Nan Yang +6 more
doaj +1 more source
Risk-based Optimization of Sensor Distribution in Roof Constructions – A Conceptual Study [PDF]
E3S Web of Conferences, 2020 The objective of placing moisture sensors in roof constructions is to warn about leakage events, and thus avoid undesirable consequences. However, considering that placing an additional sensor is directly related to increasing the total cost of the ...
Gradeci Klodian +2 more
doaj +1 more source
Nanocellulose as building block for novel materials [PDF]
, 2012 This thesis describes the fabrication of novel green materials using nanocellulose as the building block. Bacterial cellulose (BC) was used as the nanocellulose predominantly in this work. BC is highly crystalline pure cellulose with an inherent fibre
Lee, Koon-Yang, Lee, Koon-Yang
core +1 more source
Experimental investigation of frost induced damage of cement mortar [PDF]
MATEC Web of Conferences, 2019 Questions connected to influence of frost degradation on microstructure and physical properties of water saturated cement mortars and their resistance to cyclic water freezing are the objectives of research.
Wieczorek Alicja +2 more
doaj +1 more source
Building Materials Composition Influence to Sound Transmission Loss STL Reduction [PDF]
, 2013 . The development of the airport always causes the noise impact to the surrounding environment.1 Housing close to the airport will be annoyed by the aircraft noise, especially if the building is not added by absorber building materials.
Sadwikasari, Anggana Fitri +1 more
core +1 more source
The Global Warming Potential of Building Materials: An Application of Life Cycle Analysis in Nepal [PDF]
, 2017 open6siThis paper analyzes the global-warming potential of materials used to construct the walls of 3 building types—traditional, semimodern, and modern—in Sagarmatha National Park and Buffer Zone in Nepal, using the life-cycle assessment approach ...
Francesca Pierobon +5 more
core +4 more sources
Using of aerogel to improve thermal insulating properties of windows [PDF]
, 2018 For the best possible thermal-technical properties of building structures it is necessary to use materials with very low thermal conductivity. Due to the increasing thermal-technical requirements for building structures, the insulating materials are ...
Panovec, Vladan +3 more
core +1 more source
Inspecting the corrosion state of underground reinforced concrete structures
Journal of Infrastructure Preservation and Resilience, 2022 Unnoticed corrosion in underground reinforced concrete structural members – such as foundations, retaining walls, or piles – may severely threaten the integrity of structures.
Patrick Pfändler +2 more
doaj +1 more source
Functionalization of the Fine Al2O3 Abrasive by the Polyacrylamide Deposition
Medžiagotyra, 2021 In order to enhance the dispersion stability of ultra-fine Al2O3 powder in aqueous media, the alumina particles were modified with silane coupling agent KH570 at first, and then 2,2'-Azobis(2-amidinopropane) dihydrochloride (AIBA) was anchored onto the ...
Pengfei MA +5 more
doaj +1 more source
Characteristics of Silicon Dioxide Particles in PCVD Synthesizing Silica Glass Process
Journal of Nanotechnology, 2016 SiO2 nanoparticles in PCVD process were investigated by SEM, TEM, and optical emission spectra (OES). There are large spherical SiO2 particles with diameter of 50–200 nm and more small particles about 10–50 nm in PCVD process.
Yuancheng Sun +4 more
doaj +1 more source