Results 281 to 290 of about 23,415,662 (345)
Some of the next articles are maybe not open access.

Path Loss and Shadowing for UAV-to-Ground UWB Channels Incorporating the Effects of Built-Up Areas and Airframe

IEEE transactions on intelligent transportation systems (Print)
A realistic channel model is vital for designing, optimizing, and evaluating unmanned aerial vehicle (UAV)-to-ground (U2G) communication systems. This paper presents a comprehensive U2G ultra-wideband (UWB) channel model by considering the large-scale ...
Hao-Ran Ni   +7 more
semanticscholar   +1 more source

Design of cold-formed steel built-up columns subjected to local-global interactive buckling using direct strength method

, 2021
This paper presents the structural behavior of doubly-symmetric built-up cold-formed steel (CFS) columns that fail in local-global (flexural-torsional) interactive buckling modes. The built-up column investigated in this study is formed (back-to-back) by
S. Selvaraj, M. Madhavan
semanticscholar   +1 more source

Flexural behaviour of back-to-back built-up cold-formed steel channel beams: Experiments and finite element modelling

, 2021
In cold-formed steel (CFS) structures, the application of back-to-back built-up channel beams is increasing steadily. The increasing demand of CFS sections as a cost-effective design solution has led to the development of CFS built-up sections.
K. Roy   +4 more
semanticscholar   +1 more source

Tests and design of built-up section columns

, 2021
Built-up sections are increasingly used as structural elements in the cold-formed steel (CFS) industry. They are composed of two or more component sections connected by discrete fasteners, typically spaced evenly along the length and potentially with ...
D. K. Phan, K. Rasmussen, B. Schafer
semanticscholar   +1 more source

Influence of intermediate stiffeners on the axial capacity of cold-formed steel back-to-back built-up unequal angle sections

, 2021
In Cold-formed steel (CFS) structures, such as trusses, transmission towers and portal frames, the use of back-to-back built-up CFS unequal angle sections are becoming increasingly popular. In such an arrangement, screw fasteners are required at discrete
G. B. G. Ananthi   +3 more
semanticscholar   +1 more source

Design of Cold-Formed Steel Back-To-Back Connected Built-up Beams

, 2021
Built-up sections are commonly used in cold-formed steel (CFS) structures. The built-up sections are either welded or mechanically fastened based on the need and necessity.
S. Selvaraj, M. Madhavan
semanticscholar   +1 more source

The Microbiology of Built Up Poultry Litter

Journal of Applied Bacteriology, 1965
The numbers of viable bacteria in built up poultry litter were found to be 10 10 ‐10 11 /g fresh weight and appeared to be little affected by factors such as age, temperature, moisture content and pH.
openaire   +2 more sources

SDGSAT-1 nighttime light data improve village-scale built-up delineation

Remote Sensing of Environment, 2023
Cong-Rong Li   +4 more
semanticscholar   +1 more source

Built‐Up Wood Columns

Journal of Structural Engineering, 1987
Current design rules for wood columns are reviewed, and a linear elastic analysis of pin-ended built-up columns with timber connectors concentrated near the ends is presented. The analysis shows how stresses, deflections, and buckling loads depend on individual member properties, joint stiffnesses, overall geometry, and how the load is applied ...
openaire   +1 more source

Home - About - Disclaimer - Privacy