Results 71 to 80 of about 127,285 (301)
Water‐Stable Paper‐Based Laser‐Induced Graphene With Asymmetric Water Adhesion and Wettability
Advanced Materials Interfaces, EarlyView.Paper‐based electronics are attractive for sustainable and disposable devices, but often fail in wet environments. By introducing Parafilm into cellulose paper combined with laser conversion, two graphene surfaces with different water interactions are created.
Lingyin Meng +3 more
wiley +1 more source
, 2012 We observed four "water fountain" sources in the CO J=3-2 line emission with the Atacama Submillimeter Telescope Experiment (ASTE) 10 m telescope in 2010-2011. The water fountain sources are evolved stars that form high-velocity collimated jets traced by
Chong, Sze-Ning +7 more
core +1 more source
A mechanism for high-frequency oscillation in ramjet combustors and afterburners [PDF]
, 1956 An experimental investigation was made of the behavior of a small two-dimensional combustion chamber, burning a uniform mixture of air and fuel vapor under conditions of high-frequency oscillation or screech.
Marble, Frank E., Rogers, Don E.
core +1 more source
Topological Point Defects in SmC* Liquid Crystals Under Mechanical Disturbance
Advanced Materials Interfaces, EarlyView.Tangetial air jet shear inducess island formation and nucleates topological point defects in uniform SmC films. Island bounded by edge dislocation loops shrink and transform into isolated point defects under continued shear. Mechanical perturbatio provides a controllable route for defect engineering in smectric liquid crystal thin films.
Gunganist Kongklad +3 more
wiley +1 more source
Nihon Kikai Gakkai ronbunshu, 2016 Unstable behaviors of cellular premixed flames caused by hydrodynamic and diffusive-thermal instabilities under high- and low-temperature environment were studied numerically.
Satoshi KADOWAKI +5 more
doaj +1 more source
Transient combustion responses of homogeneous propellants to acoustic oscillations in axisymmetric rocket motors [PDF]
, 1997 A numerical analysis of unsteady motions in solid rocket motors has been conducted. The formulation considers a 2-D axisymmetric combustion chamber and a choke nozzle, and treats the complete conservation equations accounting for turbulence closure ...
Culick, F. E. C., Roh, T. S.
core +1 more source
Advanced Materials Technologies, EarlyView.Liquid metal direct writing is advanced from a technological and fundamental point. Utilizing a kinematic bed, printing on large surfaces with irregularities is enabled. Furthermore, a pressure‐driven flow during printing is discovered that affects the thickness of traces.
Maximilian Krack +15 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.A mask‐free and cost‐effective UV‐pico‐second laser‐based microfabrication method is proposed to fabricate large‐area biodegradable microelectrode arrays and pressure sensors. These devices demonstrate low impedance, good conformability, excellent biocompatibility, and rapid degradation, providing a new route for next‐generation transient electronics ...
Bhavani Prasad Yalagala +5 more
wiley +1 more source
Applications in Energy and Combustion ScienceThe effects of droplet diameter, overall equivalence ratio (0.8–1.5), and primary evaporation zone length (2–10 mm) on the burning velocity and thermal flame thickness in laminar n-heptane monodisperse spray flames under varying pressures (1.0–2.0 bar ...
Gulcan Ozel-Erol +2 more
doaj +1 more source
Journal of Thermal Science and Technology, 2010 Asymptotic analysis on premixed flames with high-temperature combustible mixtures was performed to elucidate the instability of flame fronts. Planar premixed flames with sufficiently low Mach numbers were treated, and a one-step irreversible chemical ...
Satoshi KADOWAKI
doaj +1 more source