Results 131 to 140 of about 192,055 (298)
Digital Actuation Control of Soft Robotic Origami With Self‐Folding Liquid Crystal Elastomer Hinges
Self‐folding soft‐rigid hybrid robotic origami is enabled by liquid crystal elastomer actuators with embedded Joule heating and closed‐loop digital control. Digitally addressable hinges provide reversible and programmable transitions between distinct folded states while maintaining actuation performance at high cycle counts (over 1500).
David C. Bershadsky +3 more
wiley +1 more source
The potential of using eco‐friendly thermoplastic polypropylene (PP)‐based insulation for high voltage direct current (HVDC) cable has been widely investigated but much less work on the PP‐based semiconducting screen (SC). Considering a long service life
Haitian Wang +4 more
doaj +1 more source
Counterion Dependent Side‐Chain Relaxation Stiffens a Chemically Doped Thienothiophene Copolymer
Oxidation of a thienothiophene copolymer, p(g3TT‐T2), via different doping strategies and dopant molecules resulted in materials with similar oxidation levels and a high electrical conductivity of ≈100 S cm−1. However, mechanical properties varied significantly, with sub‐glass transition temperatures and elastic moduli spanning from –44°C to –3°C and ...
Mariavittoria Craighero +12 more
wiley +1 more source
Instruction manual for UTEP weld gas hydrogen detector [PDF]
The instrument described in this manual was developed at the University of Texas at El Paso under contract from the National Aeronautics and Space Administration Marshall Space Flight Center.
Mcclure, John, Pang, Tonghui
core +1 more source
Meta‐Rod Mechanical Metamaterials With Programmable Reconfiguration
Existing mechanical metamaterials achieve programmable large deformations in planar square or cubic configurations, restricted by required complex boundary conditions. This research proposes a 1D metamaterial, Meta‐rod, with linear, bending, twisting, area, and volume deformation modes.
Atharva Pande, Lyes Kadem, Hang Xu
wiley +1 more source
A Si anode comprising entangled networks of cellulose and SWCNT (C‐CNT) nanocomposites as an anode electrode for a high‐performance LIB is realized by fully utilizing the generated microstructure of a novel conductive 3D scaffold via a low‐temperature and eco‐friendly process. Additionally, localized heating via photo‐thermal conversion can be utilized
Boeun Ryu +5 more
wiley +1 more source
Satellite freeze forecast system. Operating/troubleshooting manual [PDF]
Examples of operational procedures are given to assist users of the satellites freeze forecasting system (SFFS) in logging in on to the computer, executing the programs in the menu, logging off the computer, and setting up the automatic system ...
Martsolf, J. D.
core +1 more source
Conductance‐Dependent Photoresponse in a Dynamic SrTiO3 Memristor for Biorealistic Computing
A nanoscale SrTiO3 memristor is shown to exhibit dynamic synaptic behavior through the interaction of local electrical and global optical signals. Its photoresponse depends quantitatively on the conductance state, which evolves and decays over tunable timescales, enabling ultralow‐power, biorealistic learning mechanisms for advanced in‐memory and ...
Christoph Weilenmann +8 more
wiley +1 more source
MEMS Accelerometer with Screen Printed Piezoelectric Thick Film [PDF]
Bove, T. +3 more
core +2 more sources
In this report, we demonstrate that a crystalline phase of 52nm thick NiFe2O4 can be grown by RF sputtering on top of γ‐Al2O3(8nm)/SrTiO3 at a significantly low temperature (150 °C) without compromising the mobility and carrier density of the 2D electron gas at the γ‐Al2O3(8nm)/SrTiO3 interface.
Amit Chanda +11 more
wiley +1 more source

