Results 201 to 210 of about 154,014 (326)

Influence of Testing Temperature on the Mechanical Performance of Brazed Conventionally and Additively Manufactured 316L Stainless Steel Joints

open access: yesAdvanced Engineering Materials, EarlyView.
This study reports for the first time the mechanical properties of brazed joints featuring Additively manufactured parts, such parts will likely need to be joined or combined with other components, and brazing offers a way of doing this for complex shapes without distortion. A new shear test methodology developed for such joints is also described.
Frances Livera   +7 more
wiley   +1 more source

Assessing the Microstructure of SnBiZn Alloys during Semisolid Treatment

open access: yesAdvanced Engineering Materials, EarlyView.
The development of Sn‐based alloys for semisolid processing is crucial for Industry 4.0. This study investigates Sn40Bi and Sn40Bi2Zn alloys, revealing that Zn refines Sn‐rich globules by pinning dendrite boundaries. Bi saturation occurs at 60 min, while Zn enhances globule microhardness at 90 min through solid solution strengthening.
Carolina de Siqueira Simioli   +2 more
wiley   +1 more source

A Simulative Approach for the Prediction of Mesoscale Residual Stress Fields in Solution‐Strengthened Ferritic Ductile Iron

open access: yesAdvanced Engineering Materials, EarlyView.
This study presents a 3D representative volume element‐based simulation approach to predict mesoscopic residual stress and strain fields in silicon solid solution‐strengthened ductile cast iron. By modeling phase transformation kinetics with an enhanced Johnson–Mehl–Avrami–Kolmogorov model, the effects of varying cooling rates on residual stresses are ...
Lutz Horbach   +6 more
wiley   +1 more source

Process Parameter and Dimension‐Dependent Mn Vaporization During Laser Powder Bed Fusion of an Fe–Mi–Si–Cr‐Based Shape Memory Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
The functional properties of Fe–Mn–Si–Cr‐based shape memory alloys are influenced, among other things, by their chemical composition. Here, the vaporization of Mn, the most volatile element of the alloy, is investigated. It is shown that the process parameters make noninterchangeable contributions to the vaporization and that vaporization differences ...
Maylin Homfeldt, Anastasiya Toenjes
wiley   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy