Results 121 to 130 of about 110,188 (297)

Enhanced Oxidation and Thermal Shock Resistance of N‐type Mg2Si0.89(Sn0.1,Sb0.01) Thermoelectric Material via Cr0.9Si0.1 Coating

open access: yesAdvanced Engineering Materials, EarlyView.
Cr0.9Si0.1 protective coatings are developed to enhance the thermal‐shock and oxidation resistance of Mg2Si0.89(Sn0.1,Sb0.01) thermoelectric (TE) materials. The coating forms a dense and adherent barrier that suppresses oxygen diffusion and mitigates mechanical degradation during cyclic oxidation, demonstrating its potential to improve the long‐term ...
Mikdat Gurtaran   +3 more
wiley   +1 more source

Microstructural Evolution and Mechanical Performance of Plasma‐Assisted Hybrid Friction Stir Welded Dissimilar Aluminum–Copper Joints

open access: yesAdvanced Engineering Materials, EarlyView.
Plasma‐assisted hybrid friction stir welding of dissimilar AlCu joints employs localized plasma preheating to balance heat input and enhance plastic flow. The optimized process reduces axial force by up to 35%, refines the microstructure, and achieves ≈96% joint efficiency.
Deepak Kumar Yaduwanshi   +3 more
wiley   +1 more source

Influence of spontaneous nystagmus with eyes closed on computerized vestibular exam of patients with chronic peripheral

open access: yesInternational Archives of Otorhinolaryngology, 2010
Introduction: The spontaneous nystagmus with eyes closed (NEOF) can modify the results obtained during some evidence of vestibular, leading to erroneous conclusions.
Shin, Elizabeth   +2 more
doaj  

Timing versus caloric goal in nutritional therapy for critically ill patients

open access: yesNutrición Hospitalaria
Introduction: Enteral nutrition is an important therapy for severely critically ill patients. The timing and amount of energy have been highly debated. Objective: The aim of the present study was to directly compare the timing and the caloric targets in ...
Oellen Stuani Franzosi   +1 more
doaj   +1 more source

Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6

open access: yesAdvanced Engineering Materials, EarlyView.
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter   +4 more
wiley   +1 more source

Effect of obesity on autonomic nervous system [PDF]

open access: yes, 2011
The present study was carried out on 100 volunteers of which 50 subjects with BMI > 30kg/m2 were included in study group and 50 subjects with BMI < 30kg/m2 (non obese) were included in control group.
Simran Grewal, Vidushi Gupta, Int J Cur Bio Med Sci.
core  

cVEMP, oVEMP and Caloric Test Results in Individuals with Meniere’s Disease

open access: diamond, 2015
Sujeet Kumar Sinha   +2 more
openalex   +1 more source

Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study

open access: yesAdvanced Engineering Materials, EarlyView.
This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy