Results 181 to 190 of about 13,699 (264)
Early use of the reinforced concrete in the architecture of the Historicism in Austria–Hungary
Abstract The study examines the early incorporation of reinforced concrete in the architecture of Historicism in Austria–Hungary. Spanning the late 19th to early 20th centuries, the research illuminates the period's stylistic pluralism and the transformative impact of reinforced concrete.
Éva Lovra, Zoltán Bereczki
wiley +1 more source
Abstract After a blossoming pre‐World War II (WWII) period, the concrete construction industry in then‐socialist Hungary existed in a relative isolation from the Western World during the mid‐20th century. In this paper, we focus on the body of work of one of the then newly established state‐owned design offices, IPARTERV, to show how the isolation ...
Orsolya Gáspár, Péter Haba
wiley +1 more source
Impact of half‐joint failures on RC girder bridges: A robustness quantification study
Abstract The robustness of bridge structures is critical to ensuring safety and service continuity, particularly in aging infrastructure exposed to degradation and unexpected loads. Reinforced concrete (RC) half‐joint bridges—widely built in Italy between the 1950s and 1970s—exhibit specific vulnerabilities due to inspection challenges, durability ...
Paolo Martinelli, Matteo Colombo
wiley +1 more source
Abstract The preservation of reinforced concrete masterpieces from the 20th century poses a complex challenge. These structures often combine architectural, historical, and technological value, which standard engineering codes and conservation practices are not fully equipped to address. The Erasmus+ REcube project responded to this gap by promoting an
Elisabetta Margiotta Nervi +2 more
wiley +1 more source
Abstract The use of fiber reinforced concrete (FRC) in precast tunnel segments is among the most established and representative applications of this material. Over the past two decades, numerous tunnel linings were constructed with partial or total substitution of conventional steel reinforcement by fibers, this yielding to quantifiable benefits in ...
Vladimir Rusanov +4 more
wiley +1 more source
Abstract This study investigates the numerical modeling of internal tendon breaks in prestressed concrete structures and evaluates the key parameters affecting accuracy. A combined approach is followed, involving global sensitivity analysis via the Elementary Effects Method and subsequent model calibration using experimental data from distributed fiber‐
Aeneas Paul, David Sanio, Peter Mark
wiley +1 more source
Exploring the potential of Textile Reinforced Concrete for corrosion‐insensitive retaining walls
Abstract In a context where durability concerns, particularly the corrosion of steel reinforcement, remain a critical challenge for conventional reinforced concrete structures under severe exposure, Textile Reinforced Concrete (TRC) is emerging as a promising alternative.
J. Devènes +3 more
wiley +1 more source
Abstract In precast concrete structures, optimizing the design of corbels by considering the contributions of secondary reinforcement elements can significantly improve construction economy, especially when corbels are repeated multiple times. This paper proposes a strut‐and‐tie model for reinforced concrete corbels subjected to vertical and/or ...
Rejane Martins Fernandes Canha +3 more
wiley +1 more source
The challenges of GFRP RC beam design for limit states
Abstract Glass fiber reinforced polymer (GFRP) bars are used ever more frequently in concrete construction due to their non‐corrosive and anti‐magnetic properties. Their research over the past decades focused on fundamental questions, such as the design aspects of beams under flexural loads.
Szabolcs Szinvai, Tamás Kovács
wiley +1 more source

