Results 71 to 80 of about 8,566 (260)
Transient Charging of Mixed Ionic‐Electronic Conductors by Anomalous Diffusion
This article explores charge transport in mixed ionic‐electronic conductors (MIECs) through electrochemical impedance spectroscopy and transient current analysis. Focusing on PEDOT:PSS, WO3, and n‐doped PBDF, it uncovers the impact of anomalous diffusion via fractional modeling. The study reveals key correlations that deepen understanding and guide the
Heyi Zhang +9 more
wiley +1 more source
Fabrication with graphite-modified GO/PPy composites have been studied from used batteries using the Hummers method. This research was performance in four steps: graphite powder preparation, GO synthesis, GO/PPy composite synthesis, and supercapacitor ...
Muhammad Iqbal Qeis +4 more
doaj +1 more source
The water permeability of amorphous carbon dots (CDs) is demonstrated by investigating their plasticization. Novel polyamide‐based and amorphous nanoparticles are synthesized by controlling their inner packing density. Water plasticization is evidenced by the decrease of the CDs glass transition temperature with increasing the hydration degree.
Elisa Sturabotti +8 more
wiley +1 more source
Over the last decades, interest in high-quality sea-level reads and higher-accuracy tide gauges has increased because of concern about the sea-level rise induced by climate change.
Gerges M. Salama +3 more
doaj +1 more source
Electrically Readable Lateral Flow Assay Using Organic Transistors for Diagnostic Applications
Electrolyte‐gated organic field‐effect transistors (EGOFETs) are integrated with lateral flow (LF) paper fluidics to create a reusable, portable, and low‐cost point‐of‐care (PoC) diagnostic test. The devices are validated for Human Immunoglobulin G detection, achieving high sensitivity (0.1 fm), selectivity, and reproducibility with rapid results in 20–
María Jesús Ortiz‐Aguayo +4 more
wiley +1 more source
Ordered three‐dimensional anodic aluminum oxide (3D‐AAO) nanoarchitectures with longitudinal and transverse pores enable architecture‐driven metamaterials. The review maps fabrication advances, including hybrid pulse anodization, and shows how 3D‐AAO templates tailor properties across magnetism, energy, catalysis, and sensing.
Marisol Martín‐González
wiley +1 more source
Inspired by the multilayer structure of the shellfish, a novel two-dimensional (2D) composite structure consisting of graphene oxide, MoS2 and graphene oxide (G/M/G) was integrated to the flexible pressure sensing. The composite structure was prepared by
Zheyu Hu, Dabing Zhang, Yuning Zhou
doaj +1 more source
Metasurface‐engineered NC‐TENG arrays integrate tactile pressure mapping, non‐contact gesture sensing, and acoustic signal readouts in one ultrathin module, and outperforms pristine PDMS in terms of electrical output and real‐time spatial mapping for next‐gen wearables.
Injamamul Arief +12 more
wiley +1 more source
n‐Type Polymer Radio Frequency Rectifiers Operating at 18.5 GHz
Combining an n‐doped polymer semiconductor with wafer‐scale asymmetric planar electrodes featuring work function‐engineered contacts yields radio‐frequency diodes and rectifying circuits operating at up to 18.5 GHz. The devices combine scalable manufacturing with an operating frequency previously unattainable by large‐area organic electronics ...
Lazaros Panagiotidis +19 more
wiley +1 more source
Leaftronics: Bio‐Fractal Scaffolds From Leaf Venation for Low‐Waste Electronics
“Leaftronics” transforms naturally evolved leaf venation into quasi‐fractal scaffolds for sustainable electronics. Polymer‐infiltrated leaf skeletons can be used to fabricate ultra‐smooth, reflow‐ and thin‐film‐compatible decomposable substrates, while making the same lignocellulose networks conducting results in flexible transparent electrodes.
Rakesh Rajendran Nair +3 more
wiley +1 more source

