Results 61 to 70 of about 849,814 (251)

Performance of a coupled inductor for interleaved buck converter with improved step‐down conversion ratio

open access: yesIET Power Electronics, 2021
This paper proposes a dual‐winding coupled inductor (DWCI) based interleaved buck converter (IBC) with improved step‐down conversion ratio to improve the ripple in inductor currents and to achieve lower value of the output filter capacitor.
Mriganka Biswas   +2 more
doaj   +1 more source

Unified Pressure and Field Response Across Distinct Charge‐Order Regimes in Ti‐Doped CsV3Sb5

open access: yesAdvanced Functional Materials, EarlyView.
We microscopically investigate the interplay between charge order and superconductivity in a kagome superconductor across regimes of long‐ and short‐range charge order. Hydrostatic‐pressure and magnetic‐field μSR$\mu{\rm SR}$ measurements reveal remarkably similar superconducting and normal‐state time‐reversal‐symmetry‐breaking responses in both ...
P. Kral   +12 more
wiley   +1 more source

A Ripple Reduction Technique for Single Stage Switched Capacitor Converter in Ultra Low-Power Applications

open access: yesIEEE Access
One of the primary concerns in the design and practical use of fully integrated switched capacitor (SC) DC-DC converters is their load-dependent output voltage ripple.
Rakshit Dambe Nayak   +4 more
doaj   +1 more source

Capacitor Voltage Ripple Reduction Methods of Modular Multilevel Converter under Unbalanced Fault Conditions:A Comparison

open access: yes, 2018
Modular Multilevel Converter (MMC) is one of the most promising converter topology in medium/high-voltage applications. Reduction of capacitor voltage ripple during unbalanced grid conditions is very important for stable operation.
Wang, Songda   +2 more
core   +1 more source

Voltage Ripple Suppression Methods for the Capacitor in Modular Multilevel Converter Submodules Employing a Reversed Pulse Width Modulation-Switching Channel

open access: yes, 2022
Modular multilevel converters (MMCs) will be widely applied in onboard integrated power systems due to their high levels of electric power output and good-quality sine waveform outputs.
Wenguang Yang, Fei Yao, Yongyang Zhou
core   +1 more source

Lone‐Pair‐Induced Lattice Distortion in Lead‐Free Hybrid Perovskites for High‐Performance Nanogenerators

open access: yesAdvanced Functional Materials, EarlyView.
A lead‐free tin‐based hybrid perovskite is designed in which stereochemically active lone‐pair electrons on tin distort the crystal lattice and break its symmetry. Blended into a flexible polymer, the material converts pressure into electricity at milliwatt‐scale power density and continues working far below freezing, powering a commercial wristwatch ...
Majid Haji Bagheri   +12 more
wiley   +1 more source

Improved Step‐Up Z‐Source Inverter Based on Symmetric Switched Capacitor and Inductor

open access: yesIET Power Electronics
This paper introduces a new switched‑inductor Z‑source inverter topology that employs a capacitor‑assisted inductor network, achieving a significantly higher voltage‑gain factor while simultaneously reducing capacitor voltage stress over an extended duty‑
Masoumeh Gholami   +2 more
doaj   +1 more source

Minimizing Capacitance Value of Interleaved Power Factor Corrected Boost Converter for Battery Charger in Electric Vehicles

open access: yesElektronika ir Elektrotechnika, 2019
A dynamic voltage compensator (DVC) technique is presented for the minimizing of the capacitance value of the interleaved power factor corrected (PFC) boost converter for the battery charger in electric vehicles.
Omer Turksoy, Unal Yilmaz, Ahmet Teke
doaj   +1 more source

Analysis of DC-Link capacitor losses in three-level neutral point clamped and cascaded H-Bridge voltage source inverters

open access: yes
Loss estimation is a critical aspect of inverter design.The present work investigates the losses occurring in the DC-link capacitors of the three-phase three-level neutral point clamped and cascaded H-Bridge inverter topologies, by performing a harmonic ...
Sharkh, S. M.   +2 more
core   +2 more sources

Magneto‐Ionic Devices With Polymer‐Based Electrolytes

open access: yesAdvanced Functional Materials, EarlyView.
Polymer electrolytes are introduced for magneto‐ionic devices based on hydroxide and hydrogen ions. The magneto‐ionic effect results in a pronounced voltage‐controlled variation of coercivity in both devices. The switching speed is in the range of 100 ms.
Markus Gößler   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy